58062-1 Tyco Electronics, 58062-1 Datasheet - Page 4

• Manufacturer Part Number: 58062-1
• Description: HEAD ASSEMBLY TOOL FOR AMP MT CO
• Manufacturer: Tyco Electronics
• Series: AMPMODU® MTr
• Type: Terminating Head for AMPMODU MT Connectorsr

Specifications of 58062-1

• Connector Type: Receptacle
• Crimp Handle: A2031-ND, 58075-1-ND, 58338-1-ND, 931800-1-ND
• Crimp Or Cable Size: 20-30 AWG
• Crimp Application: Connectors
• Product: Tool Component
• For Use With: 58075-1 - TOOL HANDLE PNEUMATIC W/O HEAD931800-1 - ELEC PWR UNIT W/O F/TRK OR HD58338-1 - PWR BENCH ASSEMBLY W/O HEADS104305-4 - CONN RCPT 8POS DL IDC .100 GOLD104305-2 - CONN RCPT 34POS DL IDC .100 GOLD104305-1 - CONN RCPT 10POS DL IDC .100 GOLD
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Lead Free Status / RoHS Status: na, Not applicable / Not applicable
• Other names: A2040

5.2. Wire Guide
If the connector cannot be inserted into the head, the
connector is too loose in the head, or the connector
housing is damaged after termination, refer to Figure
1, and adjust the wire guide as follows:
6. INSPECTION AND MAINTENANCE
6.1. Inspection
Regular inspections should be performed by quality
control personnel with a record of quality control
inspections remaining with the personnel responsible
for the head. One inspection per month is the
recommended frequency; however, operator training
and skill, amount of use, working conditions, and
established company standards are all factors to be
considered in establishing inspection frequency.
6.2. Daily Maintenance
4 of 5
1. For pneumatic power units, disconnect the air
supply. For electric power units, disconnect the
electrical power supply.
2. Loosen the two screws on the wire guide.
3. Slide the wire guide until the connector fits
properly in the head.
4. Finger--tighten the screws.
1. Remove dust, moisture, and other contaminants
with a clean, soft brush or lint--free cloth. DO NOT
use objects that could damage the head.
2. Make sure that all components are in place and
properly secured.
Tyco Electronics Corporation
6.3. Periodic Maintenance
7. REPLACEMENT AND REPAIR
Customer--replaceable parts are listed in Figure 6.
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed
should be replaced by Tyco Electronics to ensure
quality and reliability. Order replacement parts
through your representative, or call 1--800--526--5142,
or send a facsimile of your purchase order to
717--986--7605, or write to:
For customer repair service, call 1--800--526--5136.
8. REVISION SUMMARY
Revisions to this instruction sheet include
3. Make sure that the mechanisms inside the head
function smoothly.
1. Remove any accumulated film with a suitable
cleaning agent that will not affect plastic.
2. Check for chipped, cracked, worn, or broken
areas on the head. If damage is evident, repair or
replace the head.
CUSTOMER SERVICE (038--035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
S
Updated document to corporate requirements
Rev B