1804018-1 Tyco Electronics, 1804018-1 Datasheet - Page 2

• Manufacturer Part Number: 1804018-1
• Description: TOOL SDE PC DIE SET FIBER OPTIC
• Manufacturer: Tyco Electronics

Specifications of 1804018-1

• Lead Free Status / RoHS Status: Not applicable / Not applicable

5. DIE INSPECTION
5.1. Visual Inspection
Inspection of the crimping dies should be made on a
regular basis to ensure that they have not become
worn or damaged. Inspect the crimp sections for
flattened, chipped, worn, or broken areas. If damage
or abnormal wear is evident, the dies must be
replaced.
2
. CRIMPING PROCEDURE
CAUTION
of 2
3. Insert the lower die into the moving jaw. Thread,
but do not tighten, a die retention screw through
the hole in the jaw so that the die is held in place.
4. Slowly close the tool handles, allowing the dies
to mate and align. Continue closing the handles
until the ratchet makes the fifth “click,” then tighten
both die retention screws.
1. Squeeze the tool handles together until the
ratchet releases. Allow the tool handles to open
FULLY.
2. Place the product in the appropriate nest of the
lower die.
NOTE
3. Squeeze the tool handles together until the
ratchet releases. Allow the tool handles to open
FULLY.
4. Remove the product from the tool, and inspect
the crimp according to the instruction sheet or
application specification for the connector.
the crimp sleeve in the nest according to the
instruction sheet for the connector.
Damaged product should not be used. If
damaged product is evident, it should be
removed and replaced with a new one. Product
should not be reterminated.
or proper crimp location, make sure to position
Die Assembly 180 018-1
5.2. Measured Die Opening
The dies will perform properly as long as: (1) the
product specified is correct for the application, (2) the
specified die set is used, (3) the die set has been
measured to ensure that the openings are correct,
and (4) the dies bottoms.
Figure 2 provides dimensions of the die openings.
6. REPAIR/REPLACEMENT
If the crimp cannot be made to conform to the
dimensions provided in the appropriate product
application specification, the tool and/or dies are
defective and must be replaced.
Order replacements through your representative, or
call 1–800–526–5142, or send a facsimile of your
purchase order to 717–986–7605, or write to:
7. REVISION SUMMARY
9.40 +0.03
[.370 +.001]
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
Initial release of document
Figure 2
11.87 +0.03
[.466 +.001]
08-10022
ev
A