91910-2 Tyco Electronics, 91910-2 Datasheet - Page 3

• Manufacturer Part Number: 91910-2
• Description: TOOL DIE SET PREMIUM COAXICON
• Manufacturer: Tyco Electronics
• Series: Pro-Crimper III, Coaxicon™r

Specifications of 91910-2

• Connector Type: Crimp Terminals
• Crimp Handle: A9996-ND
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Crimp Or Cable Size: -

The tool frame ratchet mechanism features an
adjustment wheel with numbered settings. If the crimp
height is not acceptable, adjust the ratchet as follows:
Rev
Shoulder of Connector
Body Butts Against Die
Screwdriver
Crimping Chamber
of Anvil Die
1. Remove the lockscrew from the ratchet
adjustment wheel.
2. Using a screwdriver, rotate the ratchet
adjustment wheel from the opposite side of the tool
frame. If a tighter crimp is required, rotate the
ratchet adjustment wheel counterclockwise to a
higher–numbered setting. If a looser crimp is
required, rotate the ratchet adjustment wheel
clockwise to a lower–numbered setting.
3. Re–install the lockscrew.
Ratchet
Adjustment
Wheel
Crimping Ferrule
Figure 3
Figure 4
(Refer to Figure 4)
Lockscrew
Tyco Electronics Corporation
The die assembly is inspected before shipment. It is
recommended that the die assembly be inspected
immediately upon arrival at your facility to ensure that
the dies have not been damaged during shipment.
The die assembly will perform correctly as long as:
(1) the product specified is correct for the application,
(2) the proper die assembly is used, (3) the die
assembly has been measured to ensure that the
openings are correct, and (4) the tool has been
adjusted correctly.
Order replacements through your local
representative, or call 1–800–526–5142, or send a
facsimile of your purchase order to 1–717–986–7605,
or write to:
4. Make a sample crimp and measure the crimp
height. If the crimp height is still unacceptable,
remove lockscrew and continue to adjust the
ratchet.
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or a clean, soft, lint–free
cloth. DO NOT use any objects that could damage
the dies or tool.
2. Make sure that the proper die retaining screws
are properly secured.
3. When the dies are not in use, store them in a
clean, dry area.
1. Remove all lubrication and accumulated film
from the dies by immersing the dies in a suitable
commercial degreaser.
2. Make certain that die retaining screws and pins
are properly secured.
3. Inspect the crimping surfaces for flattened,
chipped, worn, or cracked areas. If damage is
evident, the dies must be replaced. Refer to
Section 7, REPLACEMENT.
4. Measure the die opening to ensure that it meets
the dimensions given in Figure 5.
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
!
Damaged product should not be used. If damage
to the product is evident, it should be cut from the
wire and replaced with new product.
of 4