1-45219-2 Tyco Electronics, 1-45219-2 Datasheet - Page 2

• Manufacturer Part Number: 1-45219-2
• Description: TOOL HEAD CRIMP SPLICE 22-10AWG
• Manufacturer: Tyco Electronics

Specifications of 1-45219-2

• Connector Type: Terminals and Splices
• Crimp Handle: 1213563-1, 1213804
• Crimp Or Cable Size: 10-22 AWG
• Lead Free Status / RoHS Status: Not applicable / Not applicable

Remove the quick pins from the crimping head; then
remove the crimping head from the tool holder.
1. Remove quick pins from the adapter assembly.
Refer to Figure 1.
2. Insert crimping head into the adapter assembly.
3. After the crimping head is properly aligned,
insert the quick pins through the two holes in the
adapter and through the holes in the crimp head.
Crimping heads are coated with a preservative to
prevent rust and corrosion. Wipe this preservative
from the head, particularly from the crimping
surfaces.
To avoid personal injury, be sure to exercise
extreme caution when handling the crimp tool.
Avoid accidentally depressing the trigger control
when installing or removing crimp heads.
DO NOT operate the battery tool without the
proper crimping head installed. After crimping
head is installed, make sure that the quick pins
are properly inserted to avoid personal injury and
damage to the tool.
The quick pins will snap" into position when they
are properly inserted.
To avoid personal injury, ALWAYS disconnect the
battery from the tool before removing crimping
head.
Figure 2
1. Strip wires to dimensions shown in Figure 2. DO
NOT nick wire strand or use wires with nicked or
missing conductor strands.
2. Insert stripped wires into the splice barrel.
3. Locate the splice with the wires inserted into the
crimping dies as shown in Figure 3. the skirt of the
ECN (Nylon) splice should nest against the splice
ejector. The ends of the ECV or VS (Vinyl) splices
should rest against the end of the locator.
4. Depress the trigger to advance the moving ram.
This closes the crimp jaws in order to hold the
terminal in place. DO NOT deform the wire barrel.
ECV and VS
Type
ECN
Types
To avoid personal injury, ALWAYS keep fingers
clear of crimping jaws when operating the tool.
Never place anything within the crimping jaws
except Tyco Electronics terminals or splices.
Skirt of Nylon Closed-End
Splice Rests Against
Ejector
Figure 3
End of Vinyl Closed-End
Splice Rests Against
Locator