1-576778-0 Tyco Electronics, 1-576778-0 Datasheet - Page 4

• Manufacturer Part Number: 1-576778-0
• Description: TOOL HEAD CRIMP 24-22AWG STRATO
• Manufacturer: Tyco Electronics
• Series: Strato-Therm™r

Specifications of 1-576778-0

• Connector Type: PIDG Strato-Therm Terminal
• Crimp Handle: 1901235, 525432-1
• Crimp Or Cable Size: 22-24 AWG
• For Use With: 525432-1 - TOOL ADAPTER HEAVY HEAD ASSY152646 - CONN RING TONG 24-22AWG #8 PIDG152647 - CONN RING TONGUE 24-22AWG PIDG152645 - CONN RING STR 22-24AWG #6 PIDG152643 - CONN RING STR 22-24AWG #6 PIDG
• Lead Free Status / RoHS Status: Not applicable / Not applicable

7. MAINTENANCE AND INSPECTION PROCEDURE
Tyco Electronics recommends that a maintenance
and inspection program be performed periodically to
ensure dependable and uniform terminations. Though
recommendations call for at least one inspection a
month, frequency of inspection depends on:
The crimping head is inspected before being shipped;
however, Tyco Electronics recommends that the tool
4
Heavy Head PIDG STRATO-THERM Crimping Heads
1
2
3
4
5
6
7
of 7
1. The care, amount of use, and handling of the
hand tool.
2. The presence of abnormal amounts of dust and
dirt.
3. The degree of operator skill.
4. Your own established standards.
Insulation barrel is in firm contact with wire insulation.
Correct color code, dot code, and tool combination.
Wire size is within wire range stamped under terminal tongue.
Crimp centered on wire barrel.
End of conductor is flush with, or extends beyond end of
terminal wire barrel.
Wire insulation does not enter wire barrel.
No nicked or missing conductor strands.
1
Wire Range
Stamped Here
6
ACCEPT
2
3
4
7
5
5
Tyco Electronics Corporation
Figure 4
be inspected immediately upon arrival to ensure that
the tool has not been damaged during shipment.
7.1. Daily Maintenance
1
2
3
4
5
6
7
1. Crimping head should be immersed in a reliable
commercial degreasing compound to remove
accumulated dirt, grease, and foreign matter.
When degreasing compound is not available, head
may be wiped clean with a soft, lint–free cloth. Do
NOT use hard or abrasive objects that could
damage the crimping head.
2. Make certain that the retaining pins are in place
and that they are secured with retaining rings.
3. All pins, pivot points, and bearing surfaces
should be protected with a THIN coat of any good
SAE 20 motor oil. Do not oil excessively.
Wire insulation extruded. (Insulation crimp too tight on terminals.)
See Paragraph 5.1.
Wrong dot code and color code combination. See Figure 2.
Wire size is not within wire range stamped on terminal tongue.
Crimp not centered on wire barrel. (Terminal was not butted
against locator.)
End of conductor is not flush with or extending beyond end of wire
barrel. (Check for correct strip length.)
Wire insulation entered wire barrel.
Nicked or missing conductor strands.
6
REJECT
7
1
7
5
2
Wire Range
Stamped Here
4
3
408-10175
5
Rev
B