1752682-2 Tyco Electronics, 1752682-2 Datasheet - Page 4

• Manufacturer Part Number: 1752682-2
• Description: NEST U-DIE SPCL SOLIS FLAG 8AWG
• Manufacturer: Tyco Electronics

Specifications of 1752682-2

• Lead Free Status / RoHS Status: Not applicable / Not applicable

5.3. Periodic Inspection
Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
should remain with the dies or be made available to
supervisory personnel responsible for the the dies.
Though recommendations call for at least a monthly
inspection, the inspection frequency should be based
upon the amount of use, working conditions, operator
training and skill, and established company
standards. These inspections should be performed in
the following sequence:
A. Visual Inspection
1. Remove dust, moisture, and other contaminants
from the dies with a clean brush, or a clean, soft,
lint–free cloth. Do NOT use objects that could
damage the dies.
2. If dies are coated with oil or preservative, wipe
clean – particularly in the crimping areas – before
placing them in use.
3. When dies are not in use, make certain all
surfaces are protected with a THIN coat of any
good SAE No. 20 motor oil, and mate and store
them in a clean, dry area.
1. Remove all lubrication and accumulated film by
immersing the dies in a suitable degreaser that will
not affect paint or plastic material.
2
ACCEPT
3
1
SOLISTRAND Flag Terminal Crimping Dies
4
LAG TERMINAL
Figure 5
2. Check all surfaces for wear. Inspect the crimp
area for flattened, chipped, cracked, worn, or
broken areas. See Figure 6. If damage is evident,
the die must be replaced.
5
2
Figure 6
REJECT
4
1
3
08-8908
O