679305-1 Tyco Electronics, 679305-1 Datasheet - Page 2

• Manufacturer Part Number: 679305-1
• Description: TOOL HEAD TETRA CRIMP ADPT ASSY
• Manufacturer: Tyco Electronics

Specifications of 679305-1

• Lead Free Status / RoHS Status: Not applicable / Not applicable

2. DESCRIPTION
The adapter is designed with two crimping jaws and a
spring–loaded stop. When closed, the jaws form three
crimping chambers, each labeled by color on the jaw
of the adapter. The color indicates the wire size and
must match the insulation color of the terminal or
splice: yellow (12–10), blue (16–14), red (22–16),
black (16–14 heavy duty), and green (20–18 heavy
duty).
The stop aids in positioning the terminal or splice
between the jaws. After the operator locates the
terminal or splice and inserts the stripped wire, the
tool is activated to complete the crimp. The crimped
terminal or splice will display a crimp dot code which
indicates that the correct crimping chamber was used.
3. ADAPTER INSTALLATION AND REMOVAL
Wire Strip
Length (Typ)
{
2
Pneumatic TETRA-CRIMP Adapter 679305-1
DANGER
Trademark of Loctite Corporation
of 5
NOTE
1. Remove quick pins from the tool holder.
2. Insert adapter into the tool holder as shown in
Figure 1.
3. After adapter is properly aligned, insert and
tighten the quick pins.
i
Wire Barrel of Terminal
(Figure 1)
Crimping
Chamber
TETRA-CRIMP
Adapter 679305-1
Tyco Electronics Corporation
Figure 3
Stop
For removal, remove quick pins from tool holder
assembly; then remove adapter from tool holder
assembly.
4. CRIMPING PROCEDURE
Strip the wire to the appropriate length according to
the dimensions shown in Figure 2. Then proceed as
follows:
CAUTION
DANGER
NOTE
4. Connect tool to an adequate air supply. For
specific information on air line requirements and air
hose installation, refer to the instructions packaged
with the pneumatic tooling assembly.
1. Open the crimping jaws by squeezing the rollers
together.
2. Center the wire barrel of terminal or splice in the
appropriate crimping chamber on the jaw with the
stop.
i
!
a. If crimping a terminal, make sure the flat side
of the terminal faces away from the stop. See
Figure 3, Detail A.
b. If crimping a splice, seat the splice window
indent on the stop. See Figure 3, Detail B.
Detail A
(Figure 3)
Flat Side of
Terminal
Stop
Assembly
Detail B
Stop
Assembly
408-4099
Splice
Window
Indent
Rev
{
D