68248-1 Tyco Electronics, 68248-1 Datasheet

no-image

68248-1

Manufacturer Part Number
68248-1
Description
TOOL DIE P-G 68250-1 6AWG
Manufacturer
Tyco Electronics
Datasheet
1.68247-1.pdf (4 pages)

Specifications of 68248-1

Lead Free Status / RoHS Status
Not applicable / Not applicable
Crimping Dies 68247–1, 68248–1, and 1213098–1
are used with AMP–TAPETRONIC* Crimping
Machine 68250–1. The dies crimp PLASTI–GRIP*
Terminals onto stranded wire sizes 8 through 4 AWG.
Refer to Figure 1 to ensure compatibility of crimping
die and wire size.
For detailed information relative to tooling adjustment,
tape loading, etc., refer to the Customer Manual
(409–2586) packaged with the machine.
Reasons for reissue of this instruction sheet are
provided in Section 8, REVISION SUMMARY.
Each crimping die consists of a stationary die, a
moving die, and two die holding screws. The
applicable wire size is marked on each die. When
mated, the dies form a crimping chamber.
E
i
All dimensions in this document are in millimeters
[with inches in brackets]. Illustrations are for
reference only and are not drawn to scale.
Figure 1
Refer to the table in Figure 1 and select the crimping
die for the wire size being used. Wire size displayed
on dies must match wire size stamped under terminal
tongue.
1. Turn off main power switch and disconnect
machine from power supply.
2. Remove front applicator guard, then depress
terminal extractor and pivot it away from crimping
die holder (see Figure 2).
3. With tape release lever UP, insert moving die
(upper) into die holder and tighten holding screw.
4. Insert stationary die (lower) into die holder and
tighten holding screw.
5. Pivot terminal extractor to vertical position and
install applicator guard.
6. Lower tape release lever.
7. Connect machine to power supply and turn on
main power switch.
1. Turn off main power switch and disconnect
machine from power supply.
To avoid personal injury, ALWAYS disconnect
machine from power supply when performing
adjustment, die installation or removal, and
machine maintenance. Always keep guards and
covers in place during normal machine operation.
Figure 2

68248-1 Summary of contents

Page 1

... Figure 1 Crimping Dies 68247–1, 68248–1, and 1213098–1 are used with AMP–TAPETRONIC* Crimping Machine 68250–1. The dies crimp PLASTI–GRIP* Terminals onto stranded wire sizes 8 through 4 AWG. Refer to Figure 1 to ensure compatibility of crimping die and wire size. ...

Page 2

... Crimping Dies 68247-1, 68248-1, and 1213098-1 2. Remove front applicator guard, then depress terminal extractor and pivot it away from crimping die holder (see Figure 2). 3. With tape release lever UP, remove holding screws and dies. Figure 3 4. CRIMPING PROCEDURE 1. Strip wire to the dimensions listed in Figure 1. ...

Page 3

Each crimping die is thoroughly inspected before packaging. Since there is a possibility of damage during shipment, the crimping die should be inspected immediately upon arrival at your facility. Regular inspections should be performed by quality control personnel. A record ...

Page 4

... Crimping Dies 68247-1, 68248-1, and 1213098-1 Figure 7 CRIMPING DIE PART NUMBER ITEM ITEM 68247 REPLACEMENT AND REPAIR The parts listed in Figure 8 are customer– replaceable. A complete inventory of parts can be stocked and controlled to prevent lost time when replacement of parts is necessary. Order replacement parts through your Tyco Electronics Representative, or call 1– ...