122559-1 Tyco Electronics, 122559-1 Datasheet

SEATING TOOL FOR Z-PACK 2MM HM

122559-1

Manufacturer Part Number
122559-1
Description
SEATING TOOL FOR Z-PACK 2MM HM
Manufacturer
Tyco Electronics
Series
Z-Packr
Type
Seating Toolr
Datasheets
1.122561-1.pdf (3 pages)
2.122561-1.pdf (84 pages)

Specifications of 122559-1

Tool Type
Seating Tool
Product
Tool Component
Fits Cable/wire
2 mm
For Use With/related Products
2mm Hard Metric Connectors
For Use With
A97817 - CONN RCPT HM 125POS RT ANG 2MMA97816 - CONN RCPT HM 125POS RT ANG 2MM5646731-1 - CONN 2MM HEADER 125POS STR GOLD5100785-9 - CONN 2MM HEADER 125POS STR GOLD646731-1 - CONN 2MM HEADER 125POS STR GOLD100785-9 - CONN 2MM HEADER 125POS STR GOLD
Lead Free Status / RoHS Status
Not applicable / Not applicable
Other names
Q2684468
Seating Tool 122559–1 and Support Anvil 122561–1
are used to seat a Z–PACK HM 2mm connector. The
connector contains ACTION PIN contacts to allow
solderless pc board installation.
Read these instructions and understand them before
using the seating tool and support anvil.
Reasons for reissue of this instruction sheet are
provided in Section 7, REVISION SUMMARY.
E
i
All numerical values in this instruction sheet are
in metric units [with U.S. customary units in
brackets]. Dimensions are in millimeters [and
inches]. Figures are not drawn to scale.
Figure 1
The seating tool and support anvil are each a
one–piece design. The support anvil is positioned into
a pc board support fixture to support the pc board.
During seating, the seating tool covers the connector
and presses on the top surface of the connector when
the applicator ram applies force to the seating tool.
A pc board support must be used to provide proper
support for the pc board and alignment of the tool to
the contacts and to protect the pc board and contacts
from damage. PC Board Support Fixture 679980–[ ]
is recommended for use with this seating tool and
support anvil. For proper selection and usage
information, refer to instruction sheet 408–4038.

122559-1 Summary of contents

Page 1

... Seating Tool 122559–1 and Support Anvil 122561–1 are used to seat a Z–PACK HM 2mm connector. The connector contains ACTION PIN contacts to allow solderless pc board installation. Read these instructions and understand them before using the seating tool and support anvil. All numerical values in this instruction sheet are in metric units [with U ...

Page 2

... Seating Tool 122559-1 and Support Anvil 122561-1 NOTE As an alternative, design a pc board support fixture using the recommendations in 408-6927. i 3.2. Application Tooling Power for seating must be provided by a machine capable of supplying a downward force of 133 Newtons (N) [30 lb] per contact. Contact TOOLING ASSISTANCE CENTER at the number at the bottom of page 1 for recommendations ...

Page 3

... Seating Tool 122559-1 and Support Anvil 122561-1 5. MAINTENANCE AND INSPECTION The seating tool and support anvil are inspected before shipment recommended that the tool and support anvil be inspected immediately upon its arrival at your facility to ensure that it has not been damaged during shipment. Refer to Figure 3 for dimensions ...