1804171-1 Tyco Electronics, 1804171-1 Datasheet - Page 2

• Manufacturer Part Number: 1804171-1
• Description: TOOL REMOVAL 2PAIR RT ANG HEADER
• Manufacturer: Tyco Electronics

Specifications of 1804171-1

• Lead Free Status / RoHS Status: Not applicable / Not applicable

2
etail A
etail B
etail C
of 2
2. Slide the removal tool onto the front of the
header so that the blades fit over the header
ground shields. See Figure 3, Detail A.
3. Push the removal tool straight into the header
until the blades butt against the housing.
Straighten the puller so that the teeth of the puller
fit over the back edge of the housing. See
Figure 3, Detail B.
4. Hold the puller in place, and tighten the
thumbscrew knob.
5. Slowly pull the lever away from the pc board
until the pushers butt against the pc board. Make
sure that the removal tool moves straight. DO NOT
allow the removal tool to tilt. See Figure 3,
Detail C.
ull Lever
Blades
Figure 3
Puller
Pusher (2 Places)
Against PC Board
Ground
Shields
Housing
Teeth of Puller
Over Back Edge
of Housing
Removal Tools 180 171-1, 180 173-1, and 180 17 -1
PC Board
Header
5. MAINTENANCE
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
6. REPLACEMENT AND REPAIR
Order removal tools through your representative, or
call 1–800–526–5142, or send a facsimile of your
purchase order to 717–986–7605, or write to:
For customer repair service, call 1–800–526–5136.
7. REVISION SUMMARY
6. Pull the removal tool (with the housing) straight
away from the header. DO NOT tilt the removal
tool.
7. Loosen the thumbscrew knob, and lower the
puller away from the housing.
8. Pull the housing from the removal tool.
1. Remove dust, moisture, and other contaminants
from the removal tool with a clean, soft brush, or
lint–free cloth. DO NOT use objects that could
damage the removal tool.
2. When the removal tool is not in use, store it in a
clean, dry area.
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
Initial release of instruction sheet
08-10055
ev
A