ATTINY13V-10MMU Atmel, ATTINY13V-10MMU Datasheet - Page 113

• Manufacturer Part Number: ATTINY13V-10MMU
• Description: MCU AVR 1K ISP FLASH 1.8V 10-QFN
• Manufacturer: Atmel
• Series: AVR® ATtinyr

Specifications of ATTINY13V-10MMU

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 10MHz
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 6
• Program Memory Size: 1KB (512 x 16)
• Program Memory Type: FLASH
• Eeprom Size: 64 x 8
• Ram Size: 64 x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 10-MLF®, 10-DFN
• Processor Series: ATTINY1x
• Core: AVR8
• Data Bus Width: 8 bit
• Data Ram Size: 64 B
• Interface Type: SPI
• Maximum Clock Frequency: 10 MHz
• Number Of Programmable I/os: 6
• Number Of Timers: 1
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 4 Channel
• Package: 10MLF EP
• Device Core: AVR
• Family Name: ATtiny
• Maximum Speed: 10 MHz
• Operating Supply Voltage: 2.5|3.3|5 V
• For Use With: ATSTK600 - DEV KIT FOR AVR/AVR32770-1007 - ISP 4PORT ATMEL AVR MCU SPI/JTAGATAVRDRAGON - KIT DRAGON 32KB FLASH MEM AVRATAVRISP2 - PROGRAMMER AVR IN SYSTEMATJTAGICE2 - AVR ON-CHIP D-BUG SYSTEM
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Connectivity: -
• Lead Free Status / Rohs Status: Details

17.8.2
2535J–AVR–08/10
Programming the Flash
The Flash is organized in pages, see
the program data is latched into a page buffer. This allows one page of program data to be pro-
grammed simultaneously. The following procedure describes how to program the entire Flash
memory:
When writing or reading serial data to the ATtiny13, data is clocked on the rising edge of the
serial clock, see
for details.
Figure 17-3. Addressing the Flash which is Organized in Pages
1. Load Command “Write Flash” (see
2. Load Flash Page Buffer.
3. Load Flash High Address and Program Page. Wait after Instr. 3 until SDO goes high for
4. Repeat 2 through 3 until the entire Flash is programmed or until all data has been
5. End Page Programming by Loading Command “No Operation”.
the “Page Programming” cycle to finish.
programmed.
PROGRAM MEMORY
PROGRAM
COUNTER
PAGE
Figure 17-4 on page
PAGE ADDRESS
WITHIN THE FLASH
PCMSB
PCPAGE
114,
Table 17-9 on page
Table 17-13 on page
PAGEMSB
Figure 18-6 on page 122
PCWORD
WORD ADDRESS
WITHIN A PAGE
INSTRUCTION WORD
107. When programming the Flash,
PAGE
110).
and
Table 18-9 on page 122
PCWORD[PAGEMSB:0]:
00
01
02
PAGEEND
113