MAXQ3183-KIT Maxim Integrated Products, MAXQ3183-KIT Datasheet - Page 28

• Manufacturer Part Number: MAXQ3183-KIT
• Description: KIT EV REFRNC DSIGN FOR MAXQ3183
• Manufacturer: Maxim Integrated Products
• Series: MAXQ®r

Specifications of MAXQ3183-KIT

• Main Purpose: Power Management, Energy/Power Meter
• Embedded: No
• Utilized Ic / Part: MAXQ3183
• Primary Attributes: Polyphase AFE
• Secondary Attributes: SPI Interface
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 90-M3183-KIT

Low-Power, Multifunction, Polyphase AFE
with Harmonics and Tamper Detect
The RAM-based registers contain both operating parameters and measurement results. They are divided into a num-
ber of categories that are described in the following sections.
This register contains bits that reflect the global status of the device.
28
Bit:
Name:
Reset:
BIT
______________________________________________________________________________________
7
6
5
4
3
2
1
0
REVCFQ
PHSEQV
REVCFP
PHSEQI
CROFF
NAME
WDTR
PORF
—
—
7
0
Reserved.
When set, the high-frequency crystal has failed and the MAXQ3183 is operating from its internal ring
oscillator. Under these circumstances, energy accumulation is not accurate and the SPI bus does not
operate at full speed.
When set, the last reset was due to power-on-reset. Host should clear this bit to allow the next POR
detection.
When set, the last reset was caused by expired watchdog. The bit should be cleared (set to 0) by the
host to allow the next watchdog reset detection.
0 = The sequence of currents presented to the inputs is (-A-B-C-).
1 = The sequence of currents presented to the inputs is (-A-C-B-).
0 = The sequence of voltages presented to the voltage inputs is (-A-B-C-).
1 = The sequence of voltages presented to the voltage inputs is reversed (-A-C-B-).
This bit is meaningful only for connection systems that include all three voltages.
0 = The quantity being output on the CFQ pin is positive (direct).
1 = The quantity being output on the CFQ pin is negative (reverse).
0 = The quantity being output on the CFP pin is positive (direct).
1 = The quantity being output on the CFP pin is negative (reverse).
CROFF
6
0
PORF
5
0
WDTR
4
0
Global Status Register (STATUS) (0x000)
FUNCTION
PHSEQI
3
0
General Operating Registers
PHSEQV
RAM-Based Registers
2
0
REVCFQ
1
0
REVCFP
0
0