SV01A103AEA01B00 Murata, SV01A103AEA01B00 Datasheet - Page 13

• Manufacturer Part Number: SV01A103AEA01B00
• Description: Board Mount Motion & Position Sensors 10K OHM SMD
• Manufacturer: Murata

Specifications of SV01A103AEA01B00

• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
3. Circuit Design
(1) Recommended circuit
(2) Avoid inserting a fixed resistor in series with the sensor.
(3) Avoid using the product at a voltage that exceeds the rated
!Note
Continued from the preceding page.
voltage.
• This product is designed on the assumption that it is to be
• Because the resistive element used in this product is a
• Note, however, that if fixed resistors are connected in
• If the product is used at a voltage that exceeds the rated
used with the output terminals directly connected to the
A/D port of a microprocessor as shown in Fig.1. In other
words, the contact resistance inside the product is slightly
high based on the assumption that the connection
impedance value is of the order of megohms.
Consequently, when using the product in the circuit of
Fig.2, take steps to ensure that the connection impedance
does not fall below 1M .
(Refer to sub-section 3 of 8. Examples of Actual Trouble
and Preventive Measures.)
"carbon resistive element", its temperature characteristics
cause its total resistance value to change with the ambient
temperature. The total resistance also changes due to
changes in the external environment along with the
passage of time.
However, the resistance of each parts of the resistive
element changes uniformly, so the "output voltage
characteristics" which are determined by the voltage
division ratio due to the contact point will not be greatly
affected.
series with the product as shown in the figure at right, the
"output voltage characteristics" may be adversely affected
by the difference in the rate of change of the resistance of
the fixed resistors and that of the resistive element of the
product. For this reason, avoid connecting fixed resistor in
series with the sensor.
voltage, the resulting abnormal heat generation may
impair the function of the product.
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Product
Product
Product
SV01 Series Application Manual
Fixed Resistor
Fixed Resistor
Fig.1
Fig.2
Continued on the following page.
A/D
A/D
A/D
R51E.pdf
11
09.3.26