D10UPFP BANNER ENGINEERING, D10UPFP Datasheet - Page 7

• Manufacturer Part Number: D10UPFP
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING
• Type: Analog And Discrete Outputr

Specifications of D10UPFP

• Sensor Output: PNP
• Peak Reflow Compatible (260 C): No
• Sensor Input: Fiber Optic
• Output Type: Transistor
• Leaded Process Compatible: No
• Contact Current Max: 150mA
• Brand/series: D10 Expert™
• Current, Switching: 150 mA
• Function: Fiber Optic
• Ip Rating: IP50
• Mounting Type: DIN Rail
• Output: PNP/Voltage
• Primary Type: Photoelectric
• Sensing Mode: Selectable
• Technology: Photoelectric
• Termination: 6-Wire Cable
• Voltage, Supply: 24 VDC
• Accessories Available: Cordsets and Plastic Fiber Optic Cable
• Fiber Optic Sensor Type: Analog And Discrete Output

• TEACH on-the-fly.
• Sets a single threshold.
• Threshold is adjustable using the “+” and “-” buttons (see Manual Adjust, page 8).
Banner Engineering Corp.
www.bannerengineering.com • Tel: [phone]
• Press and hold
• Present Output
• Release Dynamic
Dynamic (+)
button.
ON/OFF conditions
while continuing to
hold Dynamic button.
button.
Push Button
•
Minneapolis, MN U.S.A.
T
T
T
T
T
T
• Hold remote line
• Present Output
• Release remote
T
T
ON/OFF conditions
while continuing
to hold remote
line low (to ground)
low (to ground).
T
line/switch.
T
T
T
D10 Expert
Remote
Dynamic TEACH
T
T
T
T
T
T
T
T
T
T
T
T
T
T
™
• Display flashes “dyn”
• Arrow icon turns red
TEACH conditions acceptable:
• Display flashes “pass,” followed
• Sensor returns to RUN mode with
• Arrow icon turns green
TEACH conditions unacceptable:
• Display flashes “fail”
• Arrow icon remains red
• Sensor returns to RUN mode
by a number (denoting contrast);
see table below.
new settings.
(Arrow icon turns green) without
changing settings.
Analog and Discrete Outputs
500+
100 - 500
32 - 99
0 - 31
Contrast Values
T
T
Excellent
Good
Low
Marginal
T
T
Result
P/N 65448 rev. E
7