SFPCA455KF4A-R1 Murata, SFPCA455KF4A-R1 Datasheet - Page 16

• Manufacturer Part Number: SFPCA455KF4A-R1
• Description: Signal Conditioning 455kHz CERAFIL for AM
• Manufacturer: Murata
• Type: Ceramic Filterr

Specifications of SFPCA455KF4A-R1

• Rad Hardened: No
• Product: Ceramic Filters
• Frequency: 455 KHz
• Frequency Range: 455 KHz +/- 1.5 KHz
• Impedance: 1.5 KOhms
• Operating Temperature Range: - 20 C to + 80 C
• Lead Free Status / RoHS Status: Compliant

7
!Note
!Note
1. Standard Reflow Soldering Condition
(1) Reflow
(2) Soldering Iron
2. Wash
1. The component will be damaged when an excessive
2. Use coupling capacitors to prevent applying D.C.
3. Do not clean or wash the component as it's not
4. Do not apply conformal coating onto the component
5. Do not use strong acidity flux, more than 0.2wt%
1. The component will be damaged when an excessive
2. Use coupling capacitors to prevent applying D.C.
3. In the case that the component is cleaned, confirm
4. In case of covering filter with over coat,
20
kHz SMD Type CERAFILr Notice
stress is applied.
voltage between input-ground, output-ground of
"CERAFIL" as D.C. current may harm the component.
hermetically sealed.
as it's not hermetically sealed.
chlorine content, in re-flow soldering.
stress is applied.
voltage between input-ground, output-ground of
"CERAFIL" as D.C. current may harm the component.
no reliability degradation is created.
conditions such as material of resin, cure
temperature, and so on should be evaluated well.
CFWCA Series Notice (Soldering and Mounting)
CFXC_/CFWCA Series Notice (Handling)
SFPCA/CFUCG/CFUCF Series Notice (Handling)
Filter is soldered once within the following temperature
condition and then being placed in natural condition for
24 hours.
Electrode is directly contacted with the tip of soldering
iron of +350 5 C for 3 1 seconds, and then being placed
in natural condition for 24hours.
The component cannot be withstand washing.
Continued from the preceding page.
• Please read rating and !CAUTION (for storage and operating, rating, soldering and mounting, handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specification or transact the approval sheet for product specification before ordering.
Please read rating and !CAUTION (for storage and operating, rating, soldering and mounting, handling) in this PDF catalog to prevent smoking and/or burning, etc.
This catalog has only typical specifications. Therefore, you are requested to approve our product specification or to transact the approval sheet for product specificaion before ordering.
5. Do not use strong acidity flux, more than 0.2wt%
6. The product, packed in the moisture-proof bag
chlorine content, in re-flow soldering.
(dry pack), is sensitive to moisture. The following
treatment is required before applying re-flow
soldering, to avoid package cracks or reliability
degradation caused by thermal stress. When unpacked,
store the component in an atmosphere of below 25 C.
and below 65% R.H., and solder within 48 hours.
240
200
100
30sec. min. 60sec.-120sec.
(140-160 C)
Pre-heating
(240 C max.)
50sec. max. 120sec. min.
(200 C)
Heating
Peak
P05E11.pdf 02.9.2
Gradual
Cooling