DS34T101GN Maxim Integrated Products, DS34T101GN Datasheet - Page 8

• Manufacturer Part Number: DS34T101GN
• Description: Communication ICs - Various Single TDM-Over-Pack et Chip AAL1, CESoPS
• Manufacturer: Maxim Integrated Products

5 Features
Global Features













Clock Synthesizers



Line Interface Units (LIUs)








____________________________________________________ DS34T101, DS34T102, DS34T104, DS34T108
TDMoP Interfaces
Ethernet Interface
End-to-end TDM synchronization through the IP/MPLS domain by on-chip, per-port TDM clock recovery
64 independent bundles/connections, each with its own:
Flexible on-chip cross-connection capability
Packet loss compensation and handling of misordered packets
Glueless SDRAM interface
Complies with MPLS-Frame Relay Alliance Implementation Agreements 4.1, 5.1 and 8.0
Complies with ITU-T standards Y.1413 and Y.1414.
Complies with Metro Ethernet Forum 3 and 8
Complies with IETF RFC 4553 (SAToP), RFC 5086 (CESoPSN) and RFC 5087 (TDMoIP)
IEEE 1146.1 JTAG boundary scan
1.8V and 3.3V Operation with 5.0V tolerant I/O
Clocks to operate LIUs, jitter attenuators, framers, BERTs and HDLC controllers can be synthesized from a
single clock input for both E1 and T1 operation (10MHz, 19.44MHz, 38.88MHz or 77.76MHz on the CLK_HIGH
pin or 1.544MHz or 2.048MHz on the MCLK pin)
Clocks to operate the TDMoP clock recovery machines can synthesized from a single clock input (10MHz,
19.44MHz, 38.88MHz or 77.76MHz on the CLK_HIGH pin)
Clock to operate TDMoP logic and SDRAM interface (50MHz or 75MHz) can be synthesized from a single
25MHz clock on the CLK_SYS pin
Receives E1, T1 and G.703 2048kHz synchronization signal
Fully software configurable including software-selectable internal Tx and Rx termination
Suitable for both short-haul and long-haul applications
Receive sensitivity options from (0dB to -12dB) to (0dB to -43dB) for E1 and to (0dB to -36dB) for T1
Receive signal level indication: 0dB to -37.5dB
Internal receive termination options for 75, 100, 110, and 120 lines
Receive monitor-mode gain settings of 14dB, 20dB, 26dB, and 32dB
Flexible transmit waveform generation
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
DS34T101: 1 E1/T1 LIU/Framer/TDMoP interface
DS34T102: 2 E1/T1 LIUs/Framers/TDMoP interfaces
DS34T104: 4 E1/T1 LIUs/Framers/TDMoP interfaces
DS34T108: 8 E1/T1 LIUs/Framers/TDMoP interfaces
All four devices: optionally 1 high-speed E3/DS3/STS-1 TDMoP interface
All four devices: each interface optionally configurable for serial operation for V.35 and RS530
One 10/100 Mbps port configurable for MII, RMII or SSMII interface format
Half or full duplex operation
VLAN support according to 802.1p and 802.1Q including stacked tags
Fully compatible with IEEE 802.3 standard
Transmit and receive queues
Configurable jitter-buffer depth
Connection-level redundancy, with traffic duplication option
Internal bundle cross-connect capability, with DS0 resolution
Any framer receiver port to any TDMoP block receive interface to maintain bundle connectivity
Any TDMoP block transmit interface to any framer transmit port to maintain bundle connectivity
8 of 16