AT94K10AL-25DQC Atmel, AT94K10AL-25DQC Datasheet - Page 50

• Manufacturer Part Number: AT94K10AL-25DQC
• Manufacturer: Atmel

Specifications of AT94K10AL-25DQC

• Device System Gates: 10000
• Propagation Delay Time: 12.7ns
• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (max): 3.6V
• Operating Supply Voltage (min): 3V
• Operating Temperature Classification: Commercial
• Operating Temperature (min): 0C
• Operating Temperature (max): 70C
• Mounting: Surface Mount
• Pin Count: 208
• Package Type: PQFP
• Lead Free Status / RoHS Status: Not Compliant

50
AT94KAL Series FPSLIC
Figure 4-9.
For single-cycle access (In/Out Commands) to I/O, the instruction has to be less than 16 bits:
In the data SRAM, the registers are located at memory addresses $00 - $1F and the I/O space is
located at memory addresses $20 - $5F.
As there are only 6 bits available to refer to the I/O space, the address is re-mapped down 2 bits.
This means the In/Out commands access $00 to $3F which goes directly to the I/O and maps to
$20 to $5F in SRAM. All other instructions access the I/O space through the $20 - $5F
addressing.
For compatibility with future devices, reserved bits should be written zero if accessed. Reserved
I/O memory addresses should never be written.
The status flags are cleared by writing a logic 1 to them. Note that the CBI and SBI instructions
will operate on all bits in the I/O register, writing a one back into any flag read as set, thus clear-
ing the flag. The CBI and SBI instructions work with registers $00 to $1F only.
$00
$3F
Memory-mapped I/O
opcode
5 bits
Used for In/Out
Instructions
I/O Space
register
r0 - 31 ($1F)
5 bits
Registers r0 - r31
Other Instructions
Memory-mapped
SRAM Space
Used for all
I/O
address
r0 - 63 ($3F)
6 bits
$5F
$1F
$00
1138I–FPSLI–1/08