SLCF064JF STEC, SLCF064JF Datasheet - Page 9

• Manufacturer Part Number: SLCF064JF
• Manufacturer: STEC
• Type: CompactFlashr

Specifications of SLCF064JF

• Density: 64MByte
• Operating Supply Voltage (typ): 3.3/5V
• Operating Temperature (min): 0C
• Operating Temperature (max): 70C
• Package Type: Not Required
• Mounting: Socket
• Pin Count: 50
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 3.18/4.75V
• Operating Supply Voltage (max): 3.465/5.25V
• Programmable: Yes
• Lead Free Status / Rohs Status: Not Compliant

SLCF064J(I)
SIGNAL DESCRIPTIONS
-WAIT
(PC Card Memory Mode)
-WAIT
(PC Card I/O Mode)
IORDY
(True IDE Mode)
GND
(PC Card Memory Mode)
GND
(PC Card I/O Mode)
GND
(True IDE Mode)
VCC
(PC Card Memory Mode)
VCC
(PC Card I/O Mode)
VCC
(True IDE Mode)
RESET
(PC Card Memory Mode)
RESET
(PC Card I/O Mode)
-RESET
(True IDE Mode)
-VS1
-VS2
(PC Card Memory Mode)
-VS1
-VS2
(PC Card I/O Mode)
-VS1
-VS2
(True IDE Mode)
Signal Name
Dir
—
—
O
O
I
13, 38
1, 50
Pin
42
41
33
40
(continued)
This signal is not used by the card, and is pulled up to VCC through a 4.7K
ohm resistor.
This signal is not used by the card, and is pulled up to VCC through a 4.7K
ohm resistor.
This signal is not used by the card, and is pulled up to VCC through a 4.7K
ohm resistor.
Ground
Ground
Ground
+5 V or 3.3V power
+5 V or 3.3V power
+5 V or 3.3V power
When RESET is high, this signal resets the card. The card is reset only at
power up if this signal is left high or open from power-up. The card can
also be reset when the soft reset bit in the Card Configuration Option
Register is set.
This signal is the same as the PC Card Memory Mode signal.
In the True IDE Mode this input pin is the active low hardware reset from
the host.
read at either 3.3 volts or 5.0 volts.
This signal is the same for all models.
This signal is not used in IDE Mode.
-VS1 is grounded, and -VS2 is not connected so that the card CIS can be
Document Part Number 61000-02805-304 July 2004
Description
COMPACTFLASH
Page 9