PKU5310ESI Ericsson Power Modules, PKU5310ESI Datasheet - Page 24

• Manufacturer Part Number: PKU5310ESI
• Description: DC/DC Converters & Regulators 33W 3.3V OUT 10A 33.02x22.86x7.50 mm
• Manufacturer: Ericsson Power Modules
• Series: PKU-Er

Specifications of PKU5310ESI

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

E
Soldering Information - Hole Mounting
The hole mounted product is intended for plated through hole
mounting by wave or manual soldering. The pin temperature
is specified to maximum to 270°C for maximum 10 seconds.
A maximum preheat rate of 4°C/s and maximum preheat
temperature of 150°C is suggested. When soldering by hand,
care should be taken to avoid direct contact between the hot
soldering iron tip and the pins for more than a few seconds in
order to prevent overheating.
A no-clean flux is recommended to avoid entrapment of
cleaning fluids in cavities inside the product or between the
product and the host board. The cleaning residues may affect
long time reliability and isolation voltage.
Delivery Package Information
The surface mount products are delivered in antistatic
injection molded trays (Jedec design guide 4.10D standard)
and in antistatic carrier tape (EIA 481 standard).
The through-hole mount products are delivered in antistatic
injection molded trays (Jedec design guide 4.10D standard).
Prepared (also subject responsible if other)
MICJAN
Approved
EAB/FJB/GM [Natalie Johansson]
PKU 5000E series
DC/DC converters, Input 18-72 V, Output up to 10 A/35 W
Carrier Tape Specifications
Material
Surface resistance
Bakeability
Tape width, W
Pocket pitch, P
Pocket depth, K
Reel diameter
Reel capacity
Reel weight
EIA standard carrier tape
User tape feed direction
Side view
Top view
Pocket pitch, P
1
0
Antistatic PS
10
The tape is not bakable
56 mm [2.2 inch]
36 mm [1.42 inch]
8.7 mm [0.343 inch]
380 mm [15 inch]
200 products /reel
2.3 kg/full reel
1
7
< Ohm/square
Elongated holes
Round holes
Pocket depth, K
Checked
See §1
Pin 1
0
Ericsson Internal
PRODUCT SPEC.
No.
5/1301-BMR 660 Uen
Date
2008-11-10
X = Vacuum pick up
All dimensions in mm [inch]
Tolerances: X.xx mm ±0.13 mm [0.005], X.x mm ±0.26 mm [0.01]
Note: tray dimensions refer to pocket center. For exact location of product pick up surface,
refer to mechanical drawing.
Tray Specifications
Material
Surface resistance
Bakability
Tray thickness
Tray capacity
Tray weight
Technical Specification
EN/LZT 146 391 R4B May 2009
© Ericsson AB
Rev
B
Antistatic PPE
10
The trays can be baked at maximum
125°C for 48 hours
18.5 mm [0.728 inch]
30 products/tray
190 g empty, 500 g full tray
5
< Ohm/square < 10
Reference
12
2 (4)
24