CY7C1354B-166AI Cypress Semiconductor Corp, CY7C1354B-166AI Datasheet - Page 12

• Manufacturer Part Number: CY7C1354B-166AI
• Manufacturer: Cypress Semiconductor Corp

Specifications of CY7C1354B-166AI

• Density: 9Mb
• Access Time (max): 3.5ns
• Sync/async: Synchronous
• Architecture: SDR
• Clock Freq (max): 166MHz
• Operating Supply Voltage (typ): 3.3V
• Address Bus: 18b
• Package Type: TQFP
• Operating Temp Range: -40C to 85C
• Number Of Ports: 1
• Supply Current: 180mA
• Operating Supply Voltage (min): 3.135V
• Operating Supply Voltage (max): 3.465V
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 100
• Word Size: 36b
• Number Of Words: 256K
• Lead Free Status / Rohs Status: Not Compliant

Document #: 38-05114 Rev. *C
The user must be aware that the TAP controller clock can only
operate at a frequency up to 10 MHz, while the SRAM clock
operates more than an order of magnitude faster. Because
there is a large difference in the clock frequencies, it is
possible that during the Capture-DR state, an input or output
will undergo a transition. The TAP may then try to capture a
signal while in transition (metastable state). This will not harm
the device, but there is no guarantee as to the value that will
be captured. Repeatable results may not be possible.
To guarantee that the boundary scan register will capture the
correct value of a signal, the SRAM signal must be stabilized
long enough to meet the TAP controller's capture set-up plus
hold times (t
captured correctly if there is no way in a design to stop (or
slow) the clock during a SAMPLE/PRELOAD instruction. If this
is an issue, it is still possible to capture all other signals and
simply ignore the value of the CK and CK captured in the
boundary scan register.
CS
and t
CH
). The SRAM clock input might not be
Once the data is captured, it is possible to shift out the data by
putting the TAP into the Shift-DR state. This places the
boundary scan register between the TDI and TDO pins.
Note that since the PRELOAD part of the command is not
implemented, putting the TAP into the Update to the
Update-DR state while performing a SAMPLE/PRELOAD
instruction will have the same effect as the Pause-DR
command.
Bypass
When the BYPASS instruction is loaded in the instruction
register and the TAP is placed in a Shift-DR state, the bypass
register is placed between the TDI and TDO pins. The
advantage of the BYPASS instruction is that it shortens the
boundary scan path when multiple devices are connected
together on a board.
Reserved
These instructions are not implemented but are reserved for
future use. Do not use these instructions.
CY7C1356B
CY7C1354B
Page 12 of 29
[+] Feedback