IBM25PPC750FL-GR0133T IBM MICROELECTRONICS, IBM25PPC750FL-GR0133T Datasheet - Page 59

• Manufacturer Part Number: IBM25PPC750FL-GR0133T
• Description: MPU 750xx RISC 32-Bit 0.13um 600MHz 1.8V/2.5V/3.3V 750-Pin CBGA Tray
• Manufacturer: IBM MICROELECTRONICS

Specifications of IBM25PPC750FL-GR0133T

• Package: 750CBGA
• Device Core: PowerPC
• Family Name: 750xx
• Number Of Cpu Cores: 1
• Data Bus Width: 32 Bit
• Maximum Speed: 600 MHz
• I/o Voltage: 1.8|2.5|3.3 V
• Operating Temperature: -40 to 105 °C

Preliminary
5.8.2 Internal Package Conduction
For the exposed-die packaging technology, shown in Table 3-3 Package Thermal Characteristics on
page 17, the following intrinsic conduction thermal resistance paths exist:
Figure 5-9 depicts the primary heat transfer path for a package with an attached heat sink mounted to a
printed circuit board.
Figure 5-9. C4 Package with Heat Sink Mounted to a Printed Circuit Board
Heat generated on the active side of the chip is conducted through the silicon, then through the heat sink
attach material (or thermal interface material), and finally to the heat sink; where it is removed by forced-air
convection. Because the silicon thermal resistance is quite small, for a first-order analysis, the temperature
drop in the silicon can be neglected. Thus, the heat sink attach material and the heat sink conduction/convec-
tive thermal resistances are the dominant terms.
The heat flow path from the die, through the chip-to-substrate balls, through the substrate, through the
substrate-to-board balls, and through the board to ambient is typically too high of a resistance to offer much
cooling. In addition, various factors make the heat flow through this path very difficult to accurately determine.
Designers must not depend on cooling the 750FL microprocessor using this means unless thermal modeling
has been confidently completed.
750flds60.fm.6.0
April 27, 2007
• Die junction-to-case thermal resistance (primary thermal path)
• Die junction-to-lead thermal resistance (not typically a significant thermal path)
• Die junction-to-ambient thermal resistance (largely dependent on customer-supplied heatsink)
External Resistance
External Resistance
Internal
Resistance
Printed Circuit Board
(Note the internal versus external package resistance.)
Heat Sink
Radiation
Radiation
Convection
Convection
Thermal Interface Material
PowerPC 750FL RISC Microprocessor
System Design Information
Chip Junction
Die/Package
Package/Leads
Page 59 of 65