LMC1982CIN National Semiconductor, LMC1982CIN Datasheet - Page 8

• Manufacturer Part Number: LMC1982CIN
• Description: IC CTRLR DGTL STEREO TONE 28DIP
• Manufacturer: National Semiconductor
• Type: Tone and Volume Controlr

Specifications of LMC1982CIN

• Applications: Audio Systems
• Mounting Type: Through Hole
• Package / Case: *
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: *LMC1982CIN

www.national.com
General Information
are serially shifted from the controller to the LMC1982. This
is followed by 8 bits of function value data. Data present in
the internal shift register is latched and the instruction is
executed.
Application Information
INPUT SELECTOR
The LMC1982’s input selector and mode control are shown
in Figure 2 . The input selector selects one of two stereo sig-
nal sources or a mute function with typical attenuation of
100 dB. The selected signals are then sent to a mode control
matrix. As shown in Table 1 , the matrix provides normal ste-
reo or can direct either channel to both LEFT or RIGHT SE-
LECT OUTPUTs. The third matrix mode is normal stereo.
The control matrix output is buffered and appears on each
channel’s respective SELECT OUT pin (6, 23). Switching
noise is kept to a minimum when mute is selected by using
a 50 k
Noise performance is optimized through the use of emitter
followers in the mode control matrix’s output. Internal 50 k
resistors are connected to each input selector pin to provide
the proper bias point for the emitter follower buffers. Each in-
ternal 50 k
half-supply (V
and 23 (SELECT OUT) that is 1.4V below V
3.1V with V
put pins (4, 5, 24, and 25), input signal should be AC coupled
through a 1 µF capacitor.
bias resistor.
+
= 9V). Since a DC voltage is present at the in-
+
bias resistor is connected to a common
/2) source. This produces a voltage at pins 6
(Continued)
+
FIGURE 1. Typical Application
/2 (typically
8
The output signal at pins 6 and 23 can be used to drive ex-
teral audio processing circuits such as noise reduction
(LM1894–DNR or Dolby) or graphic equalizers (LMC835). It
is important that if any noise reduction is used it be placed
ahead of any tone controls or equalizers in the external cir-
cuit path to preserve the frequency spectrum of the selected
input signal. Otherwise, any frequency equalization could
prevent the proper operation of the noise reduction circuit. If
no external processor is used, a capacitor should be used to
couple the SELECT OUT signals directly to pins 7 and 22,
respetively.
MINIMUM LOAD IMPEDANCE
The LMC1982 employs emitter-followers to buffer the se-
lected stereo channels. The buffered signals are available at
pins 6 and 23 (SELECT OUT). The SELECT OUT buffers op-
erate with a typical bias current 1 mA.
The Electrical Specifications table lists a maximum input sig-
nal of 2.0 V
pins. This distortion level is achieved when the minimum AC
load impedance seen by the SELECT OUT pins is 2.5 k
(2.5V/1 mA). Using lower load impedances results in clipping
at lower output levels. If the load impedance is DC-coupled,
an increased quiescent current can flow. Latch-up may occur
rms
(2.5 V
peak
) for 1% THD at the SELECT OUT
DS011028-5