STM8L152C6 STMicroelectronics, STM8L152C6 Datasheet - Page 34

• Manufacturer Part Number: STM8L152C6
• Description: STM8L-Ultra Low Power-8 bits Microcontrollers
• Manufacturer: STMicroelectronics

Specifications of STM8L152C6

• Temp. Range: - 40 °C to 85, 105 or 125 °C
• 5 Low Power Modes: Wait, Low power run (5.1 μA), Low power wait (3 μA), Active-halt with full RTC (1.3 μA), Halt (350 nA)
• Consumption: 195 μA/MHz+440μA
• Ultralow Leakage Per I/0: 50 nA
• Fast Wakeup From Halt: 4.7 μs
• Lcd: up to 4x28 segments w/ step-up converter
• 4 Channels; Supported Peripherals: ADC, DAC, SPI, I2C, USART, timers
• 2 Watchdogs: 1 Window, 1 Independent

Pin description
Table 5.
1. At power-up, the PA1/NRST pin is a reset input pin with pull-up. To be used as a general purpose pin (PA1), it can be
2. Available on STM8L152xx devices only.
3. In the 3.6 V tolerant I/Os, protection diode to V
4. [ ] Alternate function remapping option (if the same alternate function is shown twice, it indicates an exclusive choice not a
5. In the 5 V tolerant I/Os, protection diode to V
6. A pull-up is applied to PB0 and PB4 during the reset phase. These two pins are input floating after reset release.
7. In the open-drain output column, ‘T’ defines a true open-drain I/O (P-buffer, weak pull-up and protection diode to V
8. Available on STM8L151xx devices only.
9. The PA0 pin is in input pull-up during the reset phase and after reset release.
10. High Sink LED driver capability available on PA0.
Note:
4.1
34/126
39
40
1
number
configured only as output open-drain or push-pull, not as a general purpose input. Refer to Section Configuring NRST/PA1
pin as general purpose output in the STM8L15x and STM8L16x reference manual (RM0031).
duplication of the function).
not implemented).
Pin
32 28 A4
-
-
-
-
- V
- V
Medium density STM8L15x pin description (continued)
The slope control of all GPIO pins, except true open drain pins, can be programmed. By
default, the slope control is limited to 2 MHz.
System configuration options
As shown in
can be remapped on different I/O ports by programming one of the two remapping registers
described in the “ Routing interface (RI) and system configuration controller” section in the
STM8L15x and STM8L16x reference manual (RM0031).
PA0
SWIM/BEEP/IR_TIM
DD2
SS2
(9)
/[USART1_CK]
Pin name
Table 5: Medium density STM8L15x pin
(4)
(10)
/
DD
I/O
DD
S
S
is not implemented.
is not implemented.
Doc ID 15962 Rev 9
X X
Input
(9)
X
(10)
HS
Output
X
description, some alternate functions
X Port A0
IOs supply voltage
IOs ground voltage
STM8L151xx, STM8L152xx
[USART1 synchronous
clock]
and output /
Beep output / Infrared
Timer output
Default alternate
(4)
function
/ SWIM input
DD
are