ST72361AR9-Auto STMicroelectronics, ST72361AR9-Auto Datasheet - Page 136

• Manufacturer Part Number: ST72361AR9-Auto
• Description: 8-bit MCU for automotive with K Flash, 10-bit ADC, 5 Timers, SPI, 2x LINSCI
• Manufacturer: STMicroelectronics

Specifications of ST72361AR9-Auto

• Hdflash Endurance: 100 cycles, data retention 20 years at 55 °C
• 5 Power Saving Modes: halt, auto wake up from halt, active halt, wait and slow

8-bit timer (TIM8)
13.4
13.5
Note:
136/279
4
set and IC2R can be loaded) but the user must take care that the counter is reset each
period and ICF1 can also generates interrupt if ICIE is set.
When the Pulse Width Modulation (PWM) and One Pulse Mode (OPM) bits are both set, the
PWM mode is the only active one.
Low power modes
Table 52.
Interrupts
Table 53.
The 8-bit Timer interrupt events are connected to the same interrupt vector (see Interrupts
chapter). These events generate an interrupt if the corresponding Enable Control Bit is set
and the interrupt mask in the CC register is reset (RIM instruction).
WAIT
HALT
Input Capture 1 event/Counter reset in PWM mode
Input Capture 2 event
Output Compare 1 event (not available in PWM mode)
Output Compare 2 event (not available in PWM mode)
Timer Overflow event
Mode
No effect on 8-bit Timer.
Timer interrupts cause the device to exit from WAIT mode.
8-bit Timer registers are frozen.
In HALT mode, the counter stops counting until Halt mode is exited. Counting resumes
from the previous count when the MCU is woken up by an interrupt with “exit from HALT
mode” capability or from the counter reset value when the MCU is woken up by a RESET.
If an input capture event occurs on the ICAPi pin, the input capture detection circuitry is
armed. Consequently, when the MCU is woken up by an interrupt with “exit from HALT
mode” capability, the ICFi bit is set, and the counter value present when exiting from HALT
mode is captured into the ICiR register.
Effect of low power modes on TIM8
TIM8 interrupt control and wake-up capability
Interrupt event
Doc ID 12468 Rev 3
Description
Event
OCF1
OCF2
ICF1
ICF2
TOF
flag
control
Enable
OCIE
TOIE
ICIE
bit
ST72361xx-Auto
from
wait
Exit
Yes
from
Exit
halt
No