DS8007 Maxim, DS8007 Datasheet - Page 12

• Manufacturer Part Number: DS8007
• Description: The DS8007 multiprotocol dual smart card interface is a low-cost, dual smart card reader interface supporting all ISO 7816, EMV®, and GSM11-11 requirements
• Manufacturer: Maxim

Multiprotocol Dual Smart Card Interface
12
28–35
42–45
46, 47
PIN
24
25
26
27
36
37
38
39
40
41
48
______________________________________________________________________________________
AD3–AD0
INTAUX
XTAL2,
D0–D7
DELAY
NAME
XTAL1
AGND
CPB2
CPA2
ALE
V
WR
INT
RD
CS
DD
Step-Up Converter Contact 4. Connect a low-ESR capacitor of 220nF between CPB1 and CPB2.
Analog Ground
Step-Up Converter Contact 2. Connect a low-ESR capacitor of 220nF between CPA1 and CPA2.
Digital Supply Voltage. This pin should be decoupled to GND with a good quality capacitor.
8-Bit Digital I/O. This port functions as the data or address/data communication lines between the host
controller and the DS8007 for the nonmultiplexed and multiplexed operating modes, respectively.
Active-Low Parallel Bus Read Strobe Input. In multiplexed mode, this input indicates when the host
processor is reading information from the DS8007. In nonmultiplexed mode, this pin signals the current
operation is a read (RD = 1) or a write (RD = 0) when CS and WR are low.
Active-Low Parallel Bus Write Strobe Input. In multiplexed mode, this input indicates when the host
processor is writing information to the DS8007. In nonmultiplexed mode, a low on this pin signals the bus
is engaged in a read or write operation.
Active-Low Chip-Select Input. This input indicates when the DS8007 is active on the parallel bus.
Address Latch Enable Input. This signal monitors the ALE signal when the host processor bus is
operating in multiplexed mode. Connect this signal to V
Active-Low Interrupt. This output indicates an interrupt is active.
Auxiliary Interrupt Input. This pin serves as an auxiliary interrupt.
Register Selection Address Inputs. These pins function as the address input lines for the nonmultiplexed
configuration and should be connected to ground or V
Crystal Oscillators. Place a crystal with appropriate load capacitors between these pins if that is the
desired clock source. XTAL1 also acts as an input if there is an external clock source in place of a
crystal.
External Delay Capacitor Connection. Connect a capacitor from this pin to ground to set the power-on
reset delay.
FUNCTION
DD
DD
in the multiplexed configuration.
Pin Description (continued)
when operating in nonmultiplexed mode.