TMP86xy09NG Toshiba, TMP86xy09NG Datasheet - Page 77

• Manufacturer Part Number: TMP86xy09NG
• Manufacturer: Toshiba

Specifications of TMP86xy09NG

• Package: SDIP32
• Rom Types (m=mask,p=otp,f=flash): M/F
• Rom Size: 8/16
• Ram Size: 256/512
• Driver Led: 8
• Driver Lcd: -
• Spi/sio Channels: 1
• Uart/sio Channels: 1
• I2c/sio Channels: -
• High-speed Serial Output: -
• Adc 8-bit Channels: -
• Adc 10-bit Channels: 6
• Da Converter Channels: -
• Timer Counter 18-bit Channel: -
• Timer Counter 16-bit Channel: 1
• Timer Counter 8-bit Channel: 2
• Motor Channels: -
• Watchdog Timer: √
• Dual Clock: √
• Clock Gear: -
• Number Of I/o Ports: 26
• Power Supply (v): 2.7 to 5.5

Note 4: Auto-capture can be used only in the timer, event counter, and window modes.
Note 5: To set the timer registers, the following relationship must be satisfied.
Note 6: Set TFF1 to “0” in the mode except PPG output mode.
Note 7: Set TC1DRB after setting TC1M to the PPG output mode.
Note 8: When the STOP mode is entered, the start control (TC1S) is cleared to “00” automatically, and the timer stops. After the
Note 9: Use the auto-capture function in the operative condition of TC1. A captured value may not be fixed if it's read after the
Note 10:Since the up-counter value is captured into TC1DRB by the source clock of up-counter after setting TC1CR<ACAP1> to
TC1DRA > TC1DRB > 1 (PPG output mode), TC1DRA > 1 (other modes)
STOP mode is exited, set the TC1S to use the timer counter again.
execution of the timer stop or auto-capture disable. Read the capture value in a capture enabled condition.
"1". Therefore, to read the captured value, wait at least one cycle of the internal source clock before reading TC1DRB for
the first time.
Page 67
TMP86C809NG