S1F78100Y2A Epson Electronics America, Inc., S1F78100Y2A Datasheet - Page 191

• Manufacturer Part Number: S1F78100Y2A
• Description: High Precision Voltage Regulators
• Manufacturer: Epson Electronics America, Inc.

S1F71200 Series
Overcurrent Protection Circuit
The overcurrent protection circuit functions when an
overcurrent flows through the current detection resistor
during the step-up operation and the voltage at the
I
overcurrent protection function works, the transistor
drive pin SWO comes to the V
ing transistor is turned off. Since the overcurrent pro-
tection circuit links to the soft start circuit, it drops the
voltage at the SSCAP pin to the V
overcurrent detection. When the overcurrent detection
is released, the voltage at the SSCAP pin rises slowly
and the soft start operation starts.
Power lost at the current detection resistor becomes a
factor of lower efficiency. When the overcurrent pro-
tection circuit is not necessary, short-circuit the I
pin to the V
open state.
Operation of Series Regulator
S1F71200 has a built-in series regulator control circuit.
When driving the PNP transistor as an external part,
S1F71200 reduces voltage supplied to the V
constitutes a series regulator. The V
connected to the V
This series regulator operates monitoring voltage at the
V
drive current (base current of the PNP transistor) at the
EXO pin to stabilize voltage at the V
4–46
SENSE
O
pin of step-up/step-down output. It controls the
pin rises over the set voltage value. When the
SS
pin. The I
SW
pin of step-up output.
SENSE
SS
pin cannot be used in an
level and the switch-
DD2
O
SS
pin.
pin is generally
level during
DD2
pin and
SENSE
EPSON
Power Off Function
S1F71200 can control circuit operations according to
external signal control. When the POFFX pin is set to
the V
turned off. The current consumption at the power off
state is less than 1 A. When the power is off, the SWO
pin is set to the V
V
turned.
The voltage at the SSCAP pin comes to the V
and the soft start circuit controls the step-up operation
output voltage is controlled with the soft start circuit af-
ter the power off state is released. The soft start circuit
controls step-up operations after power off release.
When being set to the V
ates in general. The POFFX pin cannot be used in an
open state. When the power off function is not used,
connect the POFFX pin to the V
DD2
SS
level and respective external transistors are
level, all circuits stop and their powers are
DD
level, the EXO pin is set to the
DD
level, the POFFX pin oper-
DD1
pin.
Technical Manual
S1F70000 Series
SS
level,