XR16L788 Exar Corporation, XR16L788 Datasheet - Page 40

• Manufacturer Part Number: XR16L788
• Description: High-performance 3.3V Octal Uart
• Manufacturer: Exar Corporation

XR16L788
REVISION HISTORY
EXAR Corporation reserves the right to make changes to the products contained in this publication in order
to improve design, performance or reliability. EXAR Corporation assumes no responsibility for the use of
any circuits described herein, conveys no license under any patent or other right, and makes no represen-
tation that the circuits are free of patent infringement. Charts and schedules contained here in are only for
illustration purposes and may vary depending upon a user’s specific application. While the information in
this publication has been carefully checked; no responsibility, however, is assumed for inaccuracies.
EXAR Corporation does not recommend the use of any of its products in life support applications where
the failure or malfunction of the product can reasonably be expected to cause failure of the life support sys-
tem or to significantly affect its safety or effectiveness. Products are not authorized for use in such applica-
tions unless EXAR Corporation receives, in writing, assurances to its satisfaction that: (a) the risk of injury
or damage has been minimized; (b) the user assumes all such risks; (c) potential liability of EXAR Corpo-
ration is adequately protected under the circumstances.
Copyright 2001 EXAR Corporation
Send your UART technical inquiry with technical details to hotline: [e-mail]
Reproduction, in part or whole, without the prior written consent of EXAR Corporation is prohibited.
P1.0.0
P1.0.1
P1.0.2
P1.0.3
P1.0.4
1.1.0
1.1.1
1.1.2
1.1.3
1.1.4
Preliminary
Corrected figure 2 pin diagram on pins 16 to 30 and 39.
Corrected pins description (pin number) for TX3, RX6, DSR6# and 16/68#.
Changed part number to XR16L788, added 5V spec and target timing, and corrected RX6 pin to be 39.
Changed Icc to 5mA max. and Isleep current to 400uA max, clarified ENIR pin and MCR bits 2 and 6.
Updated Electrical Specification Tables. Added -ja and -jc values. Removed Preliminary designation.
changed V
Changed I
Deleted V
T
4.0 to 2.4V.
Updated values of AC Electrical Characteristics (T
Exar’s UART Technical Support E-mail address to first and last page.
RDA
from min =30ns to 35ns. Changed max V
OH
sleep
IL
( 0.8 to 0.7 max) and V
@ I
max @ 3.3V from 0.40mA to 0.60 mA and @ 5V from 0.40 to 3.00mA
out
=6mA. Changed condition on ICC from CLK=35MHz to “EXT Clock=2Mhz”. Changed
IH
(2.2 to 2.4 min) in electrical characteristics tables.
OCTAL UART
NOTICE
Datasheet December 2001
OL
40
AS
@5V from 0.4 to 0.55V. Changed min V
, T
AH
, T
CS
, T
RD
, T
ADS
, T
ADH
, T
WDS
, T
WDH
OH
@5V from
REV. 1.1.4
). Added