HT45R36 Holtek Semiconductor, HT45R36 Datasheet - Page 22

• Manufacturer Part Number: HT45R36
• Description: C/R to F Type 8-Bit OTP MCU
• Manufacturer: Holtek Semiconductor

www.DataSheet4U.com
C to F Application Circuit 2
The following table shows the C1, C2 and R1 values corresponding to the different crystal values. (For reference only)
Note:
Rev. 1.00
4MHz Crystal
8MHz Crystal
4MHz Resonator
8MHz Resonator
3.58MHz Crystal
3.58MHz Resonator
2MHz Crystal
2MHz Resonator
1MHz Crystal
480kHz Resonator
455kHz Resonator
429kHz Resonator
400kHz Resonator
The function of the resistor R1 is to ensure that the oscillator will switch off should low voltage conditions occur.
Such a low voltage, as mentioned here, is one which is less than the lowest value of the MCU operating volt-
age. Note however that if the LVR is enabled then R1 can be removed.
The resistance and capacitance for the reset circuit should be designed in such a way as to ensure that the
VDD is stable and remains within a valid operating voltage range before bringing RES high.
interference.
The *R resistance and *C capacitance should be consideration for the frequency of RC OSC.
R
C
* Make the length of the wiring, which is connected to the RES pin as short as possible, to avoid noise
sensor
sensor
Crystal or Resonator
1~R
1~C
sensor
sensor
16 are the resistance sensors.
16 are the capacitance sensors.
22
C1, C2
300pF
300pF
300pF
300pF
10pF
10pF
10pF
10pF
10pF
25pF
25pF
35pF
68pF
September 28, 2006
4.3k
4.7k
12k
10k
12k
10k
15k
15k
15k
12k
12k
12k
12k
R1
HT45R36