MX29LV002NCT Macronix International, MX29LV002NCT Datasheet - Page 10

• Manufacturer Part Number: MX29LV002NCT
• Description: 2M-BIT [256K x 8] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY
• Manufacturer: Macronix International

TABLE 6. EXPANDED SILICON ID CODE
READING ARRAY DATA
The device is automatically set to reading array data
after device power-up. No commands are required to re-
trieve data. The device is also ready to read array data
after completing an Automatic Program or Automatic
Erase algorithm.
After the device accepts an Erase Suspend command,
the device enters the Erase Suspend mode. The sys-
tem can read array data using the standard read tim-
ings, except that if it reads at an address within erase-
suspended sectors, the device outputs status data. Af-
ter completing a programming operation in the Erase
Suspend mode, the system may once again read array
data with the same exception. See "Erase Suspend/
Erase Resume Commands" for more infor-mation on this
mode.
The system must issue the reset command to re-en-
able the device for reading array data if Q5 goes high, or
while in the autoselect mode. See the "Reset Command"
section, next.
P/N:PM1204
Pins
Manufacture code
Device code
for MX29LV002CT
Device code
for MX29LV002CB
Sector Protection
Verification
A0
VIL
VIH VIL
VIH VIL
X
X
A1
VIL
VIH
VIH
MX29LV002C/002NC T/B
Q7
1
1
1
0
0
Q6
1
0
0
0
0
Q5
0
1
1
0
0
10
Q4
0
1
1
0
0
RESET COMMAND
Writing the reset command to the device resets the de-
vice to reading array data. Address bits are don't care for
this command.
The reset command may be written between the se-
quence cycles in an erase command sequence before
erasing begins. This resets the device to reading array
data. Once erasure begins, however, the device ignores
reset commands until the operation is complete.
The reset command may be written between the se-
quence cycles in a program command sequence be-fore
programming begins. This resets the device to reading
array data (also applies to programming in Erase Sus-
pend mode). Once programming begins, however, the
device ignores reset commands until the operation is
complete.
The reset command may be written between the se-
quence cycles in an SILICON ID READ command se-
quence. Once in the SILICON ID READ mode, the reset
command must be written to return to reading array data
(also applies to SILICON ID READ during Erase Sus-
pend).
If Q5 goes high during a program or erase operation, writ-
ing the reset command returns the device to reading ar-
ray data (also applies during Erase Suspend).
Q3
0
1
1
0
0
Q2
0
0
0
0
0
Q1
1
0
1
0
0
Q0
0
1
0
1
0
Code(Hex)
C2H
59H
5AH
01H (Protected)
00H (Unprotected)
www.DataSheet4U.com
REV. 1.0, JUN. 30, 2005