la1k-32a2s IDEC Corporation, la1k-32a2s Datasheet - Page 11

• Manufacturer Part Number: la1k-32a2s
• Description: Switchnet? Hw Series Control Units
• Manufacturer: IDEC Corporation

Communication & Networking
Legend Marking
For HW series pilot lights and illuminated pushbut-
tons, legends and symbols can be engraved on
marking plates, or printed Mylar can be inserted
under the lens for labeling purposes.
Marking Plate and Marking Film Size
Insertion Order of Marking Plate and Film
Round Lens (Flush)
Lens Film Marking
Note: Mylar is not included
Square Lens (Flush)
Lens Film Marking
Note: Mylar is not included with the control unit. When using
Style
Lens
Mylar, place the marking plate in the reverse direction.
•
•
•
•
•
Plate
Plate
Round Lens Type
Engraving must be made on the engraving
area within 0.5mm deep.
The marking plate is made of white acrylic
resin.
Mylar for printing labels is not included and
must be provided and printed by user.
Two 0.1-mm-thick fi lms or one 0.2-mm-thick
fi lm can be installed in the lens.
Recommended marking fi lm: Mylar
(Flush)
Lens Holder
Lens Holder
Engraving
ø19.6
19.4
Area
Square Lens Type
Housing
Housing
Engraving
Area
19.9
USA: 800-262-IDEC
Replacement of LED Lamps
LED lamps can be replaced using the lamp holder
tool (OR-55) from the front of the panel. The lamp
can also be replaced by removing the communica-
tion block from the operator unit.
Replacement of Lamps from Panel Front
Removal
Push in and turn the LED lamp counterclockwise
using the lamp holder tool, then the LED lamp can
be removed.
Installation
1. Insert the LED lamp into the lamp holder tool and
2. Align the contact pins of the lamp base with
hold the lamp as shown below.
thegrooves in the lamp receptacle in the operator
unit, then push in the LED lamp lightly and turn it
clockwise into place.
LED Lamp
Lamp Holder Tool (OR-55)
Lamp Receptacle
Canada: 888-317-IDEC
SwitchNet HW Series
Wiring
1. Locate the wire hole in the back of the commu-
2. With the screwdriver held in the hole, insert a
Strip the cable insulation
6 to 8mm from the end.
Anti-rotation Ring
When using the anti-rotation ring, align the TOP
marking on the operator and the p mark on the
anti-rotation ring with the recess in the mounting
hole.
Panel Cut-out (IEC947-5-1)
nication contact block. To open the spring clamp
in the wire hole, insert an optional screwdriver
(BC1S-SD0) into the adjoining screwdriver hole
until it hits the bottom. Slightly jerk the screw-
driver to insert wire easily.
wire or ferrule to the bottom of the wire hole,
then pull out the screwdriver.
Screwdriver Tip
According to DIN5264
HW Operator
AS-i+
AS-i–
3.2
+0.2
0
Anti-rotation
Ring
Screwdriver
Holes
4 places
Panel
Panel thickness
1.2 to 4.5 mm
6 to 8 mm
Locking Ring
277