la1k-32a2s IDEC Corporation, la1k-32a2s Datasheet - Page 20

• Manufacturer Part Number: la1k-32a2s
• Description: Switchnet? Hw Series Control Units
• Manufacturer: IDEC Corporation

286
Switch Guard
For Round/Square Units
Dustproof Cover
For Round Units
Round/Square Units
Determine the mounting centers in consideration of easy operation.
All dimensions in mm.
Locate the wire hole in the back of the communica-
tion contact block. To open the spring clamp in the
wire hole, insert an optional screwdriver (BC1S-SD0)
diagonally into the adjoining screwdriver hole until
it hits the bottom. Slightly jerk the screwdriver to
insert easily.
ø16.2
Waterproof Gasket
18
+0.2
0
24
24 min.
ø24
SwitchNet L6 Series
For Square Units
Rectangular Units
For Rectangular Units
ø16.2
Waterproof Gasket
24
+0.2
0
24
With the screwdriver held in the hole, insert a wire
or ferrule to the bottom of the wire hole, then pull
out the screwdriver. If an excessive force (normal
operating force: 20 to 30N) is applied to the contact
block while the L6 control unit is mounted on a
panel, the communication block may be damaged. If
the spring clamp does not open easily, remove the
communication block from the operator and try again.
25 min.
30
Minimum Mounting Centers
Accessory Dimensions
www.idec.com
Wiring
For Rectangular Units
With Switch Guard Installed
Waterproof Gasket
34
30
14
Panel thickness 0.5 to 5
Applicable Screwdriver Tip
Terminal Arrangement
Communication & Networking
Screwdriver Tip
According to DIN5264
Screwdriver Holes
With Dustproof Cover Installed
AS-i+
AS-i+
AS-i–
AS-i–
13
Panel thickness
0.5 to 5
TOP