SAB-C161K-L16M SIEMENS [Siemens Semiconductor Group], SAB-C161K-L16M Datasheet - Page 6

• Manufacturer Part Number: SAB-C161K-L16M
• Description: 16-Bit CMOS Single-Chip Microcontroller
• Manufacturer: SIEMENS [Siemens Semiconductor Group]

Pin Definitions and Functions (cont’d)
Symbol
WR/
WRL
ALE
EA
PORT0:
P0L.0 –
P0L.7,
P0H.0 -
P0H.7
PORT1:
P1L.0 –
P1L.7,
P1H.0 -
P1H.7
RSTIN
Semiconductor Group
Pin
Number
26
27
28
29 –
36
39 –
46
47 -
54
55 -
62
65
Input
Output
O
O
I
I/O
I/O
I
Function
External Memory Write Strobe. In WR-mode this pin is activated
for every external data write access. In WRL-mode this pin is
activated for low byte data write accesses on a 16-bit bus, and for
every data write access on an 8-bit bus. See WRCFG in register
SYSCON for mode selection.
Address Latch Enable Output. Can be used for latching the
address into external memory or an address latch in the
multiplexed bus modes.
External Access Enable pin. A low level at this pin during and after
Reset forces the C161 to begin instruction execution out of
external memory. A high level forces execution out of the internal
ROM. The C161 must have this pin tied to ‘0’.
PORT0 consists of the two 8-bit bidirectional I/O ports P0L and
P0H. It is bit-wise programmable for input or output via direction
bits. For a pin configured as input, the output driver is put into
high-impedance state.
In case of an external bus configuration, PORT0 serves as the
address (A) and address/data (AD) bus in multiplexed bus modes
and as the data (D) bus in demultiplexed bus modes.
Demultiplexed bus modes:
Data Path Width:
P0L.0 – P0L.7:
P0H.0 – P0H.7:
Demux bus is only available on the C161K and the C161O.
Multiplexed bus modes:
Data Path Width:
P0L.0 – P0L.7:
P0H.0 – P0H.7:
PORT1 consists of the two 8-bit bidirectional I/O ports P1L and
P1H. It is bit-wise programmable for input or output via direction
bits. For a pin configured as input, the output driver is put into
high-impedance state.
The C161K and the C161O use PORT1 as the 16-bit address bus
(A) in demultiplexed bus modes and also after switching from a
demultiplexed bus mode to a multiplexed bus mode.
Reset Input with Schmitt-Trigger characteristics. A low level at this
pin for a specified duration while the oscillator is running resets the
C161. An internal pullup resistor permits power-on reset using
only a capacitor connected to
1996 Intermediate Version
5
8-bit
D0 - D7
I/O
8-bit
AD0 - AD7
A8 - A15
V
SS
.
16-bit
D0 - D7
D8 - D15
16-bit
AD0 - AD7
AD8 - AD15
C161