NICRIO-9002 NI [National Instruments Corporation], NICRIO-9002 Datasheet - Page 3

• Manufacturer Part Number: NICRIO-9002
• Description: Small, rugged, high-reliability embedded real-time processor for intelligent stand-alone operation
• Manufacturer: NI [National Instruments Corporation]

CompactRIO Real-Time Embedded Controllers
Specifications
Network
Network interface............................... 10BaseT and 100BaseTX Ethernet
Compatibility ....................................... IEEE 802.3
Communication rates.......................... 10 Mb/s, 100 Mb/s,
Maximum cabling distance................. 100 m/segment
Memory
cRIO-9002
cRIO-9004
Power Requirements
You must use a National Electric Code (NEC) Class 2 power
source with the cRIO-900x controllers.
Recommended power supply.............. 48 W secondary, 18 to 24 VDC
Power consumption
Power supply
Physical Characteristics
Screw-terminal wiring ........................ 12 to 24 AWG copper conductor
Torque for screw terminals................. 0.5 to 0.6 N
Weight................................................. Approx. 488 g (17.2 oz)
Safety
Safety Voltages
Connect only voltages that are within these limits.
V-to-C .................................................. 30 V max, Installation Category I
Safety Standards
cRIO-900x controllers are designed to meet the requirements of the
following standards of safety for electrical equipment for measurement,
control, and laboratory use:
• EN 61010-1, IEC 61010-1
• UL 61010-1, CSA 61010-1
Hazardous Locations
U.S. (UL) .............................................. Class I, Division 2, Groups A, B,
Canada (C-UL) ..................................... Class I, Division 2, Groups A, B, C,
Europe (DEMKO) ................................. EEx nC IIC T4
Nonvolatile ..................................... 64 MB
DRAM ............................................. 32 MB
Nonvolatile ..................................... 512 MB
DRAM ............................................. 64 MB
Controller only ................................ 7 W max
Controller supplying power to
On power-up ................................... 9 to 35 V
After power-up ............................... 6 to 35 V
8 CompactRIO modules.............. 17 W
autonegotiated
wire with 10 mm (0.39 in.) of
insulation stripped from the end
C, D, T4; Class I, Zone 2, AEx nC
IIC T4
D, T4; Class I, Zone 2, Ex nC IIC T4
•
m (4.4 to 5.3 lb
•
in.)
Environmental
cRIO-900x controllers are intended for indoor use only. For outdoor use,
mount the CompactRIO system in a suitably rated enclosure.
Operating temperature
Note: To meet this operating temperature range, follow the guidelines in
the installation instructions for your CompactRIO system.
Storage temperature
Ingress protection ............................... IP 40
Operating relative humidity
Storage relative humidity
Maximum altitude............................... 2,000 m
Pollution degree (IEC 60664) .............. 2
Shock and Vibration
To meet these specifications, you must panel mount the CompactRIO
system and affix ferrules to the end of the terminal wires.
Operating vibration, random
Operating shock
Operating vibration, sinusoidal
Electromagnetic Compatibility
Emissions ............................................ EN 55011 Group1, Class A at 10 m
Immunity.............................................. Industrial levels per EN
EMC/EMI............................................. CE, C-Tick, ICES, and FCC Part 15
Note: For EMC compliance, operate this device with shielded cabling.
FCC Compliance
Go to
product in compliance with FCC regulations.
CE Compliance
This product meets the essential requirements of applicable European
directives, as amended for CE marking, as follows:
Low-voltage directive (safety) ............ 73/23/EEC
Electromagnetic compatibility
Note: Refer to the Declaration of Conformity (DoC) for this product for
any additional regulatory compliance information. To obtain the DoC
for this product, and for UL and other safety certifications, visit
ni.com/certification.
(IEC 60068-2-1, IEC 60068-2-2) ...... -40 to 70 °C
(IEC 60068-2-1, IEC 60068-2-2) ...... -40 to 85 °C
(IEC 60068-2-56) ............................. 10 to 90%, noncondensing
(IEC 60068-2-56) ............................. 5 to 95%, noncondensing
(IEC 60068-2-64) ............................. 5 g
(IEC 60068-2-27) ............................. 30 g, 11 ms half sine
(IEC 60068-2-6) ............................... 5 g, 10 to 500 Hz
directive (EMC) ............................... 89/336/EEC
ni.com/info
BUY ONLINE at ni.com or CALL 800 813 3693 (U.S.)
and enter
rdcriofcc
50 g, 3 ms half sine,
18 shocks at 6 orientations
FCC Part 15A above 1 GHz
61326:1997 + A2:2001, Table A.1
(Class A) Compliant
for information on using this
rms
, 10 to 500 Hz
3