M95128-RDW6TP STMicroelectronics, M95128-RDW6TP Datasheet - Page 12

• Manufacturer Part Number: M95128-RDW6TP
• Description: IC EEPROM 128KBIT 2MHZ 8TSSOP
• Manufacturer: STMicroelectronics

Specifications of M95128-RDW6TP

• Format - Memory: EEPROMs - Serial
• Memory Type: EEPROM
• Memory Size: 128K (16K x 8)
• Speed: 2MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 1.8 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-TSSOP
• Density: 128Kb
• Interface Type: Serial (SPI)
• Organization: 16Kx8
• Access Time (max): 150ns
• Frequency (max): 2MHz
• Write Protection: Yes
• Data Retention: 40Year
• Operating Supply Voltage (typ): 2.5/3.3/5V
• Package Type: TSSOP
• Operating Temp Range: -40C to 85C
• Supply Current: 3mA
• Operating Supply Voltage (min): 1.8V
• Operating Supply Voltage (max): 5.5V
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 8
• Maximum Clock Frequency: 2 MHz
• Access Time: 150 ns
• Supply Voltage (max): 5.5 V
• Supply Voltage (min): 1.8 V
• Maximum Operating Current: 3 mA
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 2.5 V, 3.3 V, 5 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8684-2; M95128-RDW6TP

Operating features
4
4.1
12/44
Operating features
Hold condition
The Hold (HOLD) signal is used to pause any serial communications with the device without
resetting the clocking sequence.
During the Hold condition, the Serial Data Output (Q) is high impedance, and Serial Data
Input (D) and Serial Clock (C) are Don’t Care.
To enter the Hold condition, the device must be selected, with Chip Select (S) low.
Normally, the device is kept selected, for the whole duration of the Hold condition.
Deselecting the device while it is in the Hold condition, has the effect of resetting the state of
the device, and this mechanism can be used if it is required to reset any processes that had
been in progress.
The Hold condition starts when the Hold (HOLD) signal is driven low at the same time as
Serial Clock (C) already being low (as shown in
The Hold condition ends when the Hold (HOLD) signal is driven high at the same time as
Serial Clock (C) already being low.
Figure 4
with Serial Clock (C) being low.
Figure 4.
HOLD
C
also shows what happens if the rising and falling edges are not timed to coincide
Hold condition activation
Doc ID 5798 Rev 13
Condition
Hold
Figure
4).
M95128, M95128-W, M95128-R
Condition
Hold
AI02029D