IR3082AMPBF International Rectifier, IR3082AMPBF Datasheet - Page 30

• Manufacturer Part Number: IR3082AMPBF
• Description: IC XPHASE CONTROL 9.6V 20-MLPQ
• Manufacturer: International Rectifier
• Series: XPhase™r

Specifications of IR3082AMPBF

• Applications: Processor
• Current - Supply: 12mA
• Voltage - Supply: 8.05 V ~ 16 V
• Operating Temperature: 0°C ~ 100°C
• Mounting Type: Surface Mount
• Package / Case: 20-MLPQ
• Ic Function: Control IC
• Supply Voltage Range: 8.05V To 16V
• Operating Temperature Range: 0°C To +100°C
• Digital Ic Case Style: MLPQ
• No. Of Pins: 20
• Peak Reflow Compatible (260 C): Yes
• Frequency: 1MHz
• Rohs Compliant: Yes
• Controller Type: PWM
• Filter Terminals: SMD
• Package: 20-Lead MLPQ
• Circuit: X-Phase Control IC
• Switch Freq (khz): 150kHz to 1.0MHz
• Pbf: PbF Option Available
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

METAL AND SOLDER RESIST
x The solder resist should be pulled away from the metal lead lands by a minimum of 0.06mm. The solder
x The minimum solder resist width is 0.13mm, therefore it is recommended that the solder resist is
x At the inside corner of the solder resist where the lead land groups meet, it is recommended to provide a
x The land pad should be Solder Mask Defined (SMD), with a minimum overlap of the solder resist onto
x Ensure that the solder resist in-between the lead lands and the pad land is
x The single via in the land pad should be tented with solder resist 0.4mm diameter, or 0.1mm larger than
resist mis-alignment is a maximum of 0.05mm and it is recommended that the lead lands are all Non
Solder Mask Defined (NSMD). Therefore pulling the S/R 0.06mm will always ensure NSMD pads.
completely removed from between the lead lands forming a single opening for each “group” of lead
lands.
fillet so a solder resist width of
the copper of 0.06mm to accommodate solder resist mis-alignment. In 0.5mm pitch cases it is allowable
to have the solder resist opening for the land pad to be smaller than the part pad.
aspect ratio of the solder resist strip separating the lead lands from the pad land.
the diameter of the via.
Page 30 of 33
due to the high
05/02/2006
IR3082A