ZENETSC0100ZACG Zilog, ZENETSC0100ZACG Datasheet - Page 11

• Manufacturer Part Number: ZENETSC0100ZACG
• Description: KIT ACC ETHERNET SMART CABLE
• Manufacturer: Zilog

Specifications of ZENETSC0100ZACG

• Accessory Type: Ethernet Smart Cable
• For Use With/related Products: Z8 Encore!®, Z8 Encore! XP®, eZ80Acclaim!®, ZNEO™ Dev Boards
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-4661

Restoring the Ethernet Smart Cable Factory Settings
To restore the Ethernet Smart Cable factory settings:
1. Locate the reset switch access hole in the side of the Ethernet Smart Cable housing.
2. Using a straightened paper clip, press and hold the reset switch for six seconds.
Connecting to the Target Board
Attach one end of the six-conductor ribbon cable to the Smart Cable six-pin DBG
connector. See
target board. Ensure that pin 1 on the ribbon cable (indicated by the dark stripe) is aligned
with pin 1 on the target connector. For further information on connecting the Ethernet
Smart Cable to your target board, refer to either eZ80Acclaim!
cal Note (TN0035) or Z8 Encore!
Troubleshooting Tips
If a hardware failure is suspected, contact a local ZiLOG representative for assistance.
Before submitting a problem report to ZiLOG Customer Support, follow the instructions
below.
ZDS II Cannot See the Ethernet Smart Cable
If ZDS II cannot see the Ethernet Smart Cable:
•
•
•
UM020701-0506
The Run LED will extinguish while the switch is pressed, and will illuminate again
after factory settings are restored.
Remove power from the Ethernet Smart Cable, wait five seconds, then reapply power.
Refresh the list of available smart cables. The Ethernet Smart Cable should now
appear.
Verify that the Ethernet cable you are using is the right type. (If you are connecting the
Ethernet Smart Cable directly to a PC, you must use a crossover cable. Do not use a
crossover cable to connect the Ethernet Smart Cable to a hub or standard Ethernet
connection.)
Verify that UDP port 3000 is open in your local firewall. The ZDS II software uses
UDP port 3000 to search for Ethernet Smart Cable IP addresses and requires access to
that port through your local firewall. Once the port is open, ZDS II should then be able
to identify the IP address assigned to the Ethernet Smart Cable by your DHCP server.
Figure
1. Attach the free end of the ribbon cable to the connector on the
®
Design for Debug Technical Note (TN0036).
Connecting to the Target Board
®
Design for Debug Techni-
Ethernet Smart Cable
User Manual
Page 11