CDB5530U Cirrus Logic Inc, CDB5530U Datasheet - Page 13

• Manufacturer Part Number: CDB5530U
• Description: BOARD EVAL FOR CS5530
• Manufacturer: Cirrus Logic Inc
• Type: A/Dr

Specifications of CDB5530U

• Number Of Adc's: 1
• Number Of Bits: 24
• Sampling Rate (per Second): 3.84k
• Data Interface: Serial
• Inputs Per Adc: 1 Differential
• Input Range: ±2.5 V
• Power (typ) @ Conditions: 35mW @ 5 V
• Voltage Supply Source: Analog and Digital, Dual ±
• Operating Temperature: -40°C ~ 85°C
• Utilized Ic / Part: CS5530
• Product: Data Conversion Development Tools
• Resolution: 24 bit
• Maximum Clock Frequency: 4 MHz
• Interface Type: USB
• Supply Voltage (max): 5 V
• Supply Voltage (min): 3.3 V
• For Use With/related Products: CS5530
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant
• Other names: 598-1158

DS742F3
initialization sequence, the user must also perform
a system reset sequence which is as follows: Write
a logic 1 into the RS bit of the configuration regis-
ter. This will reset the calibration registers and
other logic (but not the serial port). A valid reset
will set the RV bit in the configuration register to a
logic 1. After writing the RS bit to a logic 1, wait
8 master clock cycles, then write the RS bit back to
logic 0. Note that the other bits in the configura-
tion register cannot be written on this write cycle
as they are being held in reset until RS is set back
to logic 0. While this involves writing an entire
word into the configuration register to casue the
RS bit to go to logic 0, the RV bit is a read only bit,
therefore a write to the configuration register will
not overwrite the RV bit. After clearing the RS bit
back to logic 0, read the configuration register to
check the state of the RV bit as this indicates that a
valid reset occurred. Reading the configuration
register clears the RV bit back to logic 0.
Offset Register (1 x 32)
Power Save Select
Reset System
Input Short
Voltage Reference Select
Output Latch
Filter Rate Select
Word Rate
Unipolar/Bipolar
Open Circuit Detect
Offset (1 x 32)
Configuration Register (1 x 32)
Gain Register (1 x 32)
Gain (1 x 32)
Figure 6. CS5530 Register Diagram
Completing the reset cycle initializes the on-chip
registers to the following states:
After the configuration register has been read to
clear the RV bit, the register can then be written to
set the other function bits or other registers can be
written or read.
Once the system initialization or reset is complet-
ed, the on-chip controller is initialized into com-
mand mode where it waits for a valid command
(the first 8-bits written into the serial port are shift-
ed into the command register). Once a valid com-
mand is received and decoded, the byte instructs
the converter to either acquire data from or transfer
data to an internal register, or perform a conversion
or a calibration. The Command Register Descrip-
tions section lists all valid commands.
Configuration Register:
Offset Register:
Gain Register
Register (1 × 8)
Command
Conversion Data
Register (1 x 32)
Data (1 x 32)
00000000(H)
00000000(H)
01000000(H)
Interface
Serial
CS5530
CS
SDI
SDO
SCLK
13