KIT908E625DWBEVB Freescale Semiconductor, KIT908E625DWBEVB Datasheet - Page 16

• Manufacturer Part Number: KIT908E625DWBEVB
• Description: KIT EVAL PRELIM MM98E625/26
• Manufacturer: Freescale Semiconductor

Specifications of KIT908E625DWBEVB

• Processor To Be Evaluated: MM908E625
• Data Bus Width: 16 bit
• Interface Type: SPI
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

ADC REFERENCE PINS
(VREFL AND VREFH)
ADC. It is recommended that a high-quality ceramic
decoupling capacitor be placed between these pins.
ADC and should be tied to the same potential as VDDA via
separate traces. VREFL is the low reference supply for the
ADC and should be tied to the same potential as VSS via
separate traces.
ADC SUPPLY PINS (VDDA AND VSSA)
to-digital converter (ADC). It is recommended that a high-
quality ceramic decoupling capacitor be placed between
these pins.
tied to the same potential as EVDD via separate traces.
VSSA is the ground pin for the ADC and should be tied to the
same potential as EVSS via separate traces.
16
908E625
FUNCTIONAL DESCRIPTION
FUNCTIONAL PIN DESCRIPTION
VREFL and VREFH are the reference voltage pins for the
Important VREFH is the high reference supply for the
For details refer to the 68HC908EY16 datasheet.
VDDA and VSSA are the power supply pins for the analog-
Important VDDA is the supply for the ADC and should be
For details refer to the 68HC908EY16 datasheet.
MCU POWER SUPPLY PINS
(EVDD AND EVSS)
The MCU operates from a single power supply.
duration current demands on the power supply. To prevent
noise problems, take special care to provide power supply
bypassing at the MCU.
TEST PIN (FLSVPP)
left open (not connected) or connected to GND.
EXPOSED PAD PIN
conducts heat from the chip to the PCB board. For thermal
performance the pad must be soldered to the PCB board. It
is recommended that the pad be connected to the ground
potential.
EVDD and EVSS are the power supply and ground pins.
Fast signal transitions on MCU pins place high, short-
For details refer to the 68HC908EY16 datasheet.
This pin is for test purposes only. This pin should be either
The exposed pad pin on the bottom side of the package
Analog Integrated Circuit Device Data
Freescale Semiconductor