E62140 Renesas Electronics America, E62140 Datasheet - Page 5

• Manufacturer Part Number: E62140
• Description: DEV EMULATOR BASE UNIT H8S/2100
• Manufacturer: Renesas Electronics America
• Type: Microcontrollerr

Specifications of E62140

• Contents: E6000 Emulator Unit and 4 Logic Probes
• For Use With/related Products: H8S/214x, 213x, 212x
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

1.7
1.8
1.6.3
1.6.4
1.7.1
1.7.2
1.7.3
1.7.4
1.7.5
1.7.6
• Run... (Run menu)
• Execution Status Display on Status Bar
• Step
Emulation
The Load/Save of the Session File
Do not specify V in the FILE_LOAD command. Use the FILE_VERIFY command to verify memory.
The content of memory cannot be saved in the Elf/Dwarf2 format.
Do not set temporary breakpoints to an area wherein Software Break (User Read-only) cannot be set.
Otherwise, user program execution will not stop at the breakpoint. Moreover, the On Chip Breakpoint
may remain. In this case, delete the breakpoint from the [Breakpoints] window.
The [Go to Cursor] function uses one Software breakpoint. Note the followings:
When a break occurs during execution of the user program with a dialog box open, the state of
High-performance Embedded Workshop may not transit to the breaking state. In this case, close the
dialog box and select [Halt Program] from the [Debug] menu or press the [Halt Program] button on the
toolbar. You can check whether a break has occurred or not by the RUN lamp (LED) on the emulator
station. The RUN lamp (LED) is illuminated while the user program is running.
At memory access wait, not the address where the access is halted, but the next fetched address is
displayed.
Even standard C libraries are executed. To return to a higher-level function, enter Step Out. In a for
statement or a while statement, executing a single step does not move execution to the next line. To
move to the next line, execute two steps. Do not execute a step on a sleep instruction.
Load the file after you confirm that the H/W environment is the same as that when the last session file
was loaded.
Note that the operation of High-performance Embedded Workshop may become incorrect when Target
Clock is chosen at the time when the session file was saved and the target clock was not supplied at the
time when the session file was loaded.
To perform stepping continuously with the [Image View] or [Waveform] window open, do not
select “0 seconds” as the delay.
Do not perform stepping continuously if you have specified the realtime update of the [Image] or
[Waveform] window.
To use the [Go to Cursor] function, the number of Software breakpoints must be 255 or less.
To use the [Go to Cursor] function for the ROM area on the target system, do not use the On Chip
Breakpoint by the Software break.
FILE_LOAD Command
FILE_SAVE Command
Temporary Breakpoints
Rate of Stepping
Go to Cursor
Note on Occurrence of Breaks
Execution Status Display
Source-Level Execution
3 / 6