Z86L9800ZEM Zilog, Z86L9800ZEM Datasheet - Page 10

• Manufacturer Part Number: Z86L9800ZEM
• Description: Z86L98 ICEBOX
• Manufacturer: Zilog
• Series: ICEBOX™r
• Type: In-Circuit Emulator Systemr

Specifications of Z86L9800ZEM

• Contents: Emulator Board, Cables, Software and Documentation
• For Use With/related Products: Z86x IR Microcontroller Families
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

PS002603-0108
Note:
1.5.2
Please refer to specific Customer Procurement Specifications (CPS) or Product Informa-
tion (PI) documents for specific Limitations and Precautions for each ICEBOX
tor.
All Z8 Emulators
8. Does not support saving debugger set-up/windows.
9. Does not support short cut or hot keys for the Debugger.
10. Does not support stepping into an include file.
11. The Disassembly window-up arrow scroll does not work yet.
1. Do not put a breakpoint at addresses after a STOP instruction. This causes the pro-
2. Single-stepping into a Halt instruction causes an ICEBOX
3. Clicking on the STOP button does not always halt the ICEBOX
4. RC oscillator emulation is not supported.
5. When the software enters STOP mode and the STOP debugging button control but-
6. The emulator cannot be operated while performing ESD/EMI testing on the target
7. Ensure that the target cable is correctly aligned (pin1 to pin1) before inserting it into
8. All Z8 control registers are Write-Only unless stated otherwise.
9. The general-purpose registers values after Power-On Reset or at the initial emulator
Work around: Drag the vertical scroll bar.
gram counter to continue at that location after Stop-Mode Recovery.
appear on the screen. The ICE chip must be reset, either by the
/Reset pin on the target board or by resetting the whole ICEBOX
emulator MASTER RESET button at the back of the emulator.
application goes into Stop Mode or Halt Mode, the only way to halt the emulator
execution is by doing a Stop- Mode Recovery (as defined by the user program). The
application can also be reset by using the emulator MASTER RESET button; how-
ever, this reset the whole ICEBOX
ton is pressed, any SMR source on the application board is activated, and the emula-
tor jumps back to address 000C hex, which is normal. But when continuing the
program with a GO command from 000C hex, a POR reset is performed, resetting
all control registers.
board.
the target system. Incorrect alignment can damage the emulator/or the target system.
use are different than the actual device. The emulator self-test always leaves the

.
Product Specification

“Fatal Error” message


execution. If the
by pressing the
Z86L98ZEM

/Emula-
6