SAK-XC888C-6FFI 5V AC Infineon Technologies, SAK-XC888C-6FFI 5V AC Datasheet - Page 79

• Manufacturer Part Number: SAK-XC888C-6FFI 5V AC
• Description: IC MCU 8BIT FLASH 64-LQFP
• Manufacturer: Infineon Technologies
• Series: XC8xxr

Specifications of SAK-XC888C-6FFI 5V AC

• Core Processor: XC800
• Core Size: 8-Bit
• Speed: 103.2MHz
• Connectivity: CAN, SSI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 48
• Program Memory Size: 24KB (24K x 8)
• Program Memory Type: FLASH
• Ram Size: 1.75K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 64-LFQFP
• For Use With: B158-H8743-X-X-7600IN - KIT STARTER XC886/888
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Other names: SP000253405

1) BSL mode is automatically entered if no valid password is installed and data at memory address 0000H equals
2) OSC is bypassed in MultiCAN BSL mode
3) Normal user mode with standard JTAG (TCK,TDI,TDO) pins for hot-attach purpose.
Note: The boot options are valid only with the default set of UART and JTAG pins.
3.8
The Clock Generation Unit (CGU) allows great flexibility in the clock generation for the
XC886/888. The power consumption is indirectly proportional to the frequency, whereas
the performance of the microcontroller is directly proportional to the frequency. During
user program execution, the frequency can be programmed for an optimal ratio between
performance and power consumption. Therefore the power consumption can be
adapted to the actual application state.
Features
•
•
•
•
•
The CGU consists of an oscillator circuit and a PLL. In the XC886/888, the oscillator can
be from either of these two sources: the on-chip oscillator (9.6 MHz) or the external
oscillator (4 MHz to 12 MHz). The term “oscillator” is used to refer to both on-chip
oscillator and external oscillator, unless otherwise stated. After the reset, the on-chip
oscillator will be used by default.The external oscillator can be selected via software. In
addition, the PLL provides a fail-safe logic to perform oscillator run and loss-of-lock
detection. This allows emergency routines to be executed for system recovery or to
perform system shut down.
Data Sheet
zero.
Phase-Locked Loop (PLL) for multiplying clock source by different factors
PLL Base Mode
Prescaler Mode
PLL Mode
Power-down mode support
Clock Generation Unit
72
Functional Description
XC886/888CLM
V1.2, 2009-07