SAF-XE164G-96F66L AC Infineon Technologies, SAF-XE164G-96F66L AC Datasheet - Page 73

• Manufacturer Part Number: SAF-XE164G-96F66L AC
• Description: IC MCU 16BIT FLASH 100-LQFP
• Manufacturer: Infineon Technologies
• Series: XE16xr

Specifications of SAF-XE164G-96F66L AC

• Core Processor: C166SV2
• Core Size: 16-Bit
• Speed: 66MHz
• Connectivity: CAN, EBI/EMI, I²C, LIN, SPI, SSC, UART/USART, USI
• Peripherals: I²S, POR, PWM, WDT
• Number Of I /o: 75
• Program Memory Size: 768KB (768K x 8)
• Program Memory Type: FLASH
• Ram Size: 82K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 11x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-LFQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Other names: SP000363763; SP000363764

4.2
These parameters are static or average values that may be exceeded during switching
transitions (e.g. output current).
The XE164 can operate within a wide supply voltage range from 3.0 V to 5.5 V.
However, during operation this supply voltage must remain within 10 percent of the
selected nominal supply voltage. It cannot vary across the full operating voltage range.
Because of the supply voltage restriction and because electrical behavior depends on
the supply voltage, the parameters are specified separately for the upper and the lower
voltage range.
During operation, the supply voltages may only change with a maximum speed of
dV/dt < 1 V/ms.
Leakage current is strongly dependent on the operating temperature and the voltage
level at the respective pin. The maximum values in the following tables apply under worst
case conditions, i.e. maximum temperature and an input level equal to the supply
voltage.
The value for the leakage current in an application can be determined by using the
respective leakage derating formula (see tables) with values from that application.
The pads of the XE164 are designed to operate in various driver modes. The DC
parameter specifications refer to the current limits in
Table 13
Port Output Driver
Mode
Strong driver
Medium driver
Weak driver
1) An output current above |
Data Sheet
For any group of 16 neighboring output pins, the total output current in each direction (Σ
remain below 50 mA.
DC Parameters
Current Limits for Port Output Drivers
I
OXnom
Maximum Output Current
(
V
10 mA
4.0 mA
0.5 mA
I
OLmax
DDP
| may be drawn from up to three pins at the same time.
≥ 4.5 V
, -
I
OHmax
)
1)
V
10 mA
2.5 mA
0.5 mA
DDP
71
< 4.5 V
Table
Nominal Output Current
(
V
2.5 mA
1.0 mA
0.1 mA
I
XE166 Family Derivatives
DDP
OLnom
13.
≥ 4.5 V
, -
Electrical Parameters
I
OHnom
)
V
2.5 mA
1.0 mA
0.1 mA
I
OL
DDP
V2.1, 2008-08
and Σ-
< 4.5 V
XE164x
I
OH
) must