AT90LS2343-4SC Atmel, AT90LS2343-4SC Datasheet - Page 4
![IC MCU 2K FLASH 4MHZ LV 8-SOIC](/photos/6/50/65032/453-8-soic_sml.jpg)
AT90LS2343-4SC
Manufacturer Part Number
AT90LS2343-4SC
Description
IC MCU 2K FLASH 4MHZ LV 8-SOIC
Manufacturer
Atmel
Series
AVR® 90LSr
Specifications of AT90LS2343-4SC
Core Processor
AVR
Core Size
8-Bit
Speed
4MHz
Connectivity
SPI
Peripherals
Brown-out Detect/Reset, POR, WDT
Number Of I /o
5
Program Memory Size
2KB (1K x 16)
Program Memory Type
FLASH
Eeprom Size
128 x 8
Ram Size
128 x 8
Voltage - Supply (vcc/vdd)
2.7 V ~ 6 V
Oscillator Type
Internal
Operating Temperature
0°C ~ 70°C
Package / Case
8-SOIC (5.3mm Width), 8-SOP, 8-SOEIAJ
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Data Converters
-
Comparison between
AT90S/LS2323 and
AT90S/LS2343
Pin Descriptions
AT90S/LS2323
VCC
GND
Port B (PB2..PB0)
RESET
XTAL1
XTAL2
4
AT90S/LS2323/2343
chip, the Atmel AT90S2323/2343 is a powerful microcontroller that provides a highly
flexible and cost-effective solution to many embedded control applications.
The AT90S2323/2343 AVR is supported with a full suite of program and system devel-
opment tools including: C compilers, macro assemblers, program debugger/simulators,
in-circuit emulators and evaluation kits.
The AT90S/LS2323 is intended for use with external quartz crystal or ceramic resonator
as the clock source. The start-up time is fuse-selectable as either 1 ms (suitable for
ceramic resonator) or 16 ms (suitable for crystal). The device has three I/O pins.
The AT90S/LS2343 is intended for use with either an external clock source or the inter-
nal RC oscillator as clock source. The device has five I/O pins.
Table 1 summarizes the differences in features of the two devices.
Table 1. Feature Difference Summary
Supply voltage pin.
Ground pin.
Port B is a 3-bit bi-directional I/O port with internal pull-up resistors. The Port B output
buffers can sink 20 mA. As inputs, Port B pins that are externally pulled low, will source
current if the pull-up resistors are activated.
Port B also serves the functions of various special features.
Port pins can provide internal pull-up resistors (selected for each bit). The Port B pins
are tri-stated when a reset condition becomes active.
Reset input. An external reset is generated by a low level on the RESET pin. Reset
pulses longer than 50 ns will generate a reset, even if the clock is not running. Shorter
pulses are not guaranteed to generate a reset.
Input to the inverting oscillator amplifier and input to the internal clock operating circuit.
Output from the inverting oscillator amplifier.
Part
On-chip Oscillator Amplifier
Internal RC Clock
PB3 available as I/O pin
PB4 available as I/O pin
Start-up time
AT90S/LS2323
yes
no
never
never
1 ms/16 ms
AT90S/LS2343
no
yes
internal clock mode
always
16 µs fixed
1004D–09/01