SD8XA-004G-000000 SanDisk, SD8XA-004G-000000 Datasheet - Page 53

• Manufacturer Part Number: SD8XA-004G-000000
• Description: SSD ULTRA320 SCSI 4GB
• Manufacturer: SanDisk
• Series: Ultra320r

Specifications of SD8XA-004G-000000

• Memory Size: 4GB
• Memory Type: FLASH
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: FFD35-U3S-4-X-P80-P; FFD35-U3S-4-X-P80-P

2. Remove the PC cover.
3. Before connecting the SSD to the host adapter, check the adapter‟s memory, I/O and IRQ
4. Configure the SSD header settings as described in Section
5. Connect either the 68-pin ribbon cable between the SSD and the adapter, or the 80-pin SSD
6. Verify that the SCSI bus is properly terminated.
7. Connect the power cable from the PC power supply to the SSD. (Not required for 80-pin
8. Mount the SSD in a free 3.5” drive bay.
9. Close the PC cover.
10. Power on the PC. The host adapter‟s BIOS sign-on message is displayed listing all installed
Note: If you encounter any problems, refer to Section ‎ 1 2 for troubleshooting.
53
settings and verify that they do not conflict with any other devices installed in the system.
connector to the 80-pin socket. Neither the host adapter nor the SSD must be at the physical
end of the cable, unless they are the only two devices connected to the bus. If additional
drives are present in the system, verify that the cable runs from device to device in a
continuous manner, without branches.
SCA-2 connector).
devices. You are now ready to use the SSD.
Product Specification and User Manual
‎
1 1.5.
SSD (Formerly FFD) Ultra320 SCSI 3.5"
43-PS-0305-00 Rev. 2.2