RR1220P-104-B-T5 Susumu, RR1220P-104-B-T5 Datasheet - Page 5

• Manufacturer Part Number: RR1220P-104-B-T5
• Description: RES 100K OHM 1/10W .1% 0805 SMD
• Manufacturer: Susumu
• Series: RRr

Specifications of RR1220P-104-B-T5

• Resistance (ohms): 100K
• Power (watts): 0.1W, 1/10W
• Composition: Thin Film
• Temperature Coefficient: ±25ppm/°C
• Tolerance: ±0.1%
• Size / Dimension: 0.079" L x 0.049" W (2.00mm x 1.25mm)
• Height: 0.016" (0.40mm)
• Lead Style: Surface Mount (SMD - SMT)
• Package / Case: 0805 (2012 Metric)
• Resistance In Ohms: 100K
• Case: 0805 (2012 metric)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Other names: RR1220P-104-B; RR1220P104B; RR12P100KBTR

TITLE:
6.1.4 Insulation resistance
6.1.5 Voltage proof
Method;
Specification;
Method;
Specification;
Place the specimen on the groove of metal
plate so that the edge of metal block
positions almost center of both electrodes,
with the surface of insulation enclosure
located
pressurize the block by a force of 1.0±0.2
N.
The test voltage shall be 100±15Ｖd.c.,
and maintain this voltage for about 1 min.
The insulation resistance shall then be
measured while applying the voltage.
For other procedures, refer to IEC
60115-1, Sub-clause 4.6.
(1)Between electrodes and insulating enclosure.
(2)Between electrodes and base material.
The resistor shall be tested as shown in paragraph 6.1.4.
The test voltage shall be a voltage of 200V (a.c. r.m.s.) between both electrode.
The voltage is gradually increased at a rate of about 100 V/s. from almost 0 V to the specified voltage
and maintained as it is for 60s. +10/0s., then gradually decreased to almost 0 V.
For other procedures, refer to IEC 60115-1, Sub-clause 4.7.
Change in resistance
Without damage by flash over (spark, arcing), burning or breakdown etc.
Chip resistor RR1220 series
downward
Specification for
or
:
upward
±(0.5%+0.05Ω)
and
Measurement point A on metallic block
SUSUMU
CO.,LTD
Base material
R 0.5
㎜
1000MΩ or more
100MΩ or more
SPEC.NO:
Insulating enclosure surface
RR00-1097
Specimen
Insulating plate
M easurement point B
Presurization by
on m etallic plate
Rev. No.
0
5/14
spring