STEVAL-PCC012V1 STMicroelectronics, STEVAL-PCC012V1 Datasheet - Page 16

• Manufacturer Part Number: STEVAL-PCC012V1
• Description: BOARD DEM CONN GATEWAY STM32F107
• Manufacturer: STMicroelectronics
• Series: STM32r
• Type: Other Power Managementr

Specifications of STEVAL-PCC012V1

• Main Purpose: Interface, Connectivity
• Embedded: Yes, MCU, 32-Bit
• Utilized Ic / Part: STM32F107
• Primary Attributes: Ethernet and 4 Digital/Analog Connectors
• Secondary Attributes: On-Board LEDs and Joystick
• Interface Type: Ethernet, USB, I2C, SPI, UART
• Operating Supply Voltage: 3.3 V
• Product: Power Management Development Tools
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: STM32F107xx
• Other names: 497-10757

Configuration
5.12
5.12.1
5.12.2
16/43
Wi-Fi optional modules
There are two positions for optional Wi-Fi modules:
Table 14.
Wi-Fi optional module-1 U9 settings
Table 15.
Wi-Fi optional module-2 U10 settings and signal description
Table 16.
U10 - module-2
GPIO4 - SD_CMD
(3-pin resistor)
(3-pin resistor)
GPIO9 - SD_CLK
U9 - module-1
GPIO5 - SD_D0
GPIO6 - SD_D1
GPIO7 - SD_D2
Signal on U10
GPIO8 - SD_3
Position
Jumper
JP4
JP5
Optional Wi-Fi modules configuration
Wi-Fi optional module-1 U9 settings
Wi-Fi optional module-2 U10 settings and signal description
JTGENPB7 is pulled to GND.
The jumper with resistance of 10 kΩ must be set as
shown:
JTGENPB7 is pulled to +3.3 V.
The jumper with resistance of 10 kΩ must be set as
shown:
JTGRNPB6 is pulled to GND.
The jumper with resistance of 10 kΩ must be set as
shown:
JTGTN is pulled to +3.3 V.
The jumper with resistance of 10 kΩ must be set as
shown:
SPI1 + CS_Wi-Fi
Interface used
SDIO description
USART1
Doc ID 17009 Rev 1
SCK
IRQ
DO
NC
CS
DI
Description
These signals are shared with I
extension connector, refer to
JP2, JP3 must be configured accordingly.
SPI description
MOSI
MISO
SCK
SS
—
—
Note
Section
STM32 SPI signals
2
C for MEMS
Configuration
SCS_N
5.6.
MOSI
MISO
SCK
—
—
UM0896