ATAB5429-9-B Atmel, ATAB5429-9-B Datasheet - Page 15

• Manufacturer Part Number: ATAB5429-9-B
• Description: BOARD BASESTATN UHF RCVR 915MHZ
• Manufacturer: Atmel
• Type: Transceiver, UHFr

Specifications of ATAB5429-9-B

• Frequency: 915MHz
• Product: RF Modules
• For Use With/related Products: Wireless BlackBird
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

5219A–WIRE–04/07
Operating the Transceivers
2-10
HOW TO EXECUTE THE “LIGHT SENSOR” FEATURE:
SINGLE-SENSOR mode: After one transceiver is put into MASTER mode, the MAS-
TER polls the REMOTE with ID #1. The MASTER starts sending packets and
establishes communication with the REMOTE. The MASTER cycles through 3 screens:
(1) M LIGHT, with AVR logo and antenna icon (blinking), and a 4-digit number, (2)
LOCAL and a 4-digit number, (3) REMOTE and a 4-digit number. The REMOTE
cycles through the same 3 screens as the master, displaying R LIGHT instead of M
LIGHT and no 4-digit number.
MULTI SENSOR mode: This mode is similar to the SINGLE SENSOR mode except that
each successive transmission addresses the next incremental REMOTE ID, up to the
largest ID # set in the MULTI SENSOR menu. In order to do this mode successfully, a
specific power-up sequence is required. For example, if the largest ID # is set to 3, the
MASTER will poll REMOTE 1, then REMOTE 2, then REMOTE 3, and the repeat con-
tinually until the demo is terminated.
x KBPS - sets data rate
*WAIT*, blinking antenna - transceiver is in REMOTE mode
SINGLE SENSOR - sets single-sensor mode
MULTI SENSOR - sets multi-sensor mode
Note: All transceivers except ONE (regardless of a single- or multi-sensor demo) should be
P - sets data rate and goes to *WAIT*, antenna blinking
L - goes to *WAIT*, antenna blinking
U,D - changes data rate (1,5,10 kbps for ASK; 1,5,10,20 kbps for FSK)
R - goes to SINGLE SENSOR
L - goes to LIGHT SENSOR
P - sets sensor mode and goes to S ADDR x
L - goes to S ADDR x
U,D - toggles between SINGLE SENSOR and MULTI SENSOR
S ADDR x - sets the address of the REMOTE sensors to poll
P - sets sensor mode and goes to S ADDR x
L - goes to S ADDR x
U,D - toggles between SINGLE SENSOR and MULTI SENSOR
S ADDR x - sets the number of REMOTE sensors to poll
Note: this should be set to 1 if only one sensor is polled
left as a REMOTE at the *WAIT*, blinking antenna display. Proceed with ONLY ONE
transceiver through the remaining menus.
P - sets number and puts radio into MASTER mode
L - puts radio into MASTER mode
U,D - changes number of sensors to poll (1 - 254)
P - sets number and puts radio into MASTER mode
L - puts radio into MASTER mode
U,D - changes number of sensors to poll (1 - 254)
ATAB542x-x-WB User Guide