XK-Z11-EBP Digi International, XK-Z11-EBP Datasheet - Page 10

• Manufacturer Part Number: XK-Z11-EBP
• Description: XBEE DEVELOPMENT KIT
• Manufacturer: Digi International
• Type: Transceiver, XBeer

Specifications of XK-Z11-EBP

• Frequency: 2.4GHz
• Wireless Frequency: 2.4 GHz
• Interface Type: RS-232, Ethernet, USB
• Modulation: DSSS
• Security: 128 bit AES
• Operating Voltage: 3.3 V
• Output Power: 50 mW
• Antenna: Dipole
• Operating Temperature Range: - 40 C to + 85 C
• For Use With/related Products: XBee Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 602-1170

10
LED/button
Power LED
Status LED
ZigBee/XBee
Link LED
ZigBee/XBee
Activity LED
Ethernet Link
LED
Ethernet
Activity LED
Reset button
Light Pattern
Blue
Not illuminated
Yellow
1-1-1 blinking
yellow
1-5-1 blinking
yellow
Other blinking
yellow
Green
Solid green
Fast blinking (20
Hz) green
Slow (1 Hz)
blinking green
Off
Yellow
Solid yellow
Blinking green
N/A
Color and
For technical support, call 1-800-903-8430 (US only)
Power is applied.
No power.
Blinks during product initialization and factory reset, using the light
patterns below.
During normal device operation after initialization and factory reset,
this LED is off and should never blink. If it blinks constantly, contact
Digi Technical Support.
Firmware is initializing.
Device configuration has been restored to its factory defaults.
Contact Digi Technical Support.
Indicates that the XBee RF module in the gateway has associated with
an XBee network:
For more information on this indicator, see the description of the D5
(DIO5 Configuration) parameter in the product manual for the XBee
module.
XBee module in gateway is associated (or coordinator is started).
An Ident (identify) button has been pressed on a remote node.
XBee module in gateway is not associated.
XBee module in gateway is disabled or not recognized.
On for 25 ms when data is sent or received from the XBee module in
the gateway.
Ethernet link is up.
Ethernet traffic is on the link.
Single press: Performs equivalent of a power-cycle.
Press and hold: Resets device configuration settings to factory
defaults (factory reset).
Description