XK-Z11-EBP Digi International, XK-Z11-EBP Datasheet - Page 15

• Manufacturer Part Number: XK-Z11-EBP
• Description: XBEE DEVELOPMENT KIT
• Manufacturer: Digi International
• Type: Transceiver, XBeer

Specifications of XK-Z11-EBP

• Frequency: 2.4GHz
• Wireless Frequency: 2.4 GHz
• Interface Type: RS-232, Ethernet, USB
• Modulation: DSSS
• Security: 128 bit AES
• Operating Voltage: 3.3 V
• Output Power: 50 mW
• Antenna: Dipole
• Operating Temperature Range: - 40 C to + 85 C
• For Use With/related Products: XBee Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 602-1170

LED and button descriptions/behaviors
LED/button
I/O and
Associate/
Power LEDs
RSSI
(signal
strength)
LEDs
Reset button
Ident button
(SW1 on the
interface board)
Indicate RF module activity:
•
•
•
Indicate the amount of fade margin present in an active wireless link. The fade margin is the
difference between the incoming signal strength and the module's receiver sensitivity.
•
•
•
•
Performs equivalent of a power-cycle.
Performs actions for commissioning the XBee module in a network. Consecutive button
presses must occur within 800ms second of each other to perform desired actions.
Button
press
Single
Two
Four
Yellow (top LED): Serial Data Out (to host)
Green (middle): Serial Data In (from host)
Red (bottom): Associate/Power Indicator. Indicates both power to the interface board
and the network association status for the XBee module in the interface board.
Solid red: XBee module powered and not associated to a network.
Blinking red: XBee module has associated to a network.
For more information on this indicator, see the description of the D5
(DIO5 Configuration) parameter in the product manual for the XBee module.
3 LEDs on: Very Strong Signal (> 30 dB fade margin)
2 LEDs on: Strong Signal (> 20 dB fade margin)
1 LED on: Moderate Signal (> 10 dB fade margin)
0 LED on: Weak Signal (< 10 dB fade margin)
For technical support, call 1-800-903-8430 (US only)
association
Associated
Unassociated
Associated
Associated/
Unassociated
Network
•
•
•
•
Temporarily enables joining on the unit and the entire
network for 1 minute (if the XBee module’s NJ command
setting is less than 255). If joining is permanently enabled on
a module (NJ = 255), joining remains permanently enabled,
and this button press has no effect.
Unit leaves PAN, if associated, and issues a factory reset to
restore default parameters. Default PAN ID is 0.
If unit is asleep, wakes unit for 30 seconds.
Sends a Node Identification broadcast transmission. All
devices receiving this transmission blink their Associate
LED rapidly for 1 second. All API devices that receive this
transmission send a Node Identification frame out their
UART (universal asynchronous receiver/transmitter) (API
ID 0x95).
If unit is asleep, wakes unit for 30 seconds.
Blinks a numeric error code on the Assc LED, indicating
the cause of join failure.
1 blink: Scan found no PANs.
2 blinks: Scan found no valid PANs based on current SC
(Scan Channel) and ID (PAN ID) settings.
3 blinks: Valid Coordinator or Routers found, but they are
not allowing joining (NJ expired).
7 blinks: Node Joining attempt failed.
10 blinks: Coordinator Start attempt failed.
Description
Connect the gateway and USB interface board
Action
15